REMOTE CONTROL | (CONTINUED) |
DVD setup
The remote control is programmed with DVD codes for power on, power off, play, stop,
1)Find the DVD player brand from the list of codes shown below.
2)Slide the first
3)Press and hold down the DISPLAY button.
4)With the DISPLAY button held down, enter the first code number listed with the 10 key pad.
5)Release the DISPLAY button.
6)Confirm the operation of the DVD player.
•If your DVD player does not respond to the first code, try the others listed. If it does not respond to any code, try the Search Codes Function as shown below.
•After you program your remote, some DVD buttons may not work properly. If some buttons do not work properly, use the remote control which came with your DVD player.
DVD Player | CODES | DVD Player | CODES |
|
|
|
|
Aiwa | 043 | Raite | 033 |
Apex | 040 | RCA | 021, 026 |
Denon | 020, 037 | Sampo | 034 |
Hitachi | 030, 031 | Samsung | 030 |
JVC | 000 | Sharp | 028 |
Kenwood | 035 | Silvania | 038 |
Konka | 039 | Sony | 024, 045, 046, 047 |
Mitsubishi | 025 | Technics | 020 |
Onkyo | 041 | Toshiba | 023 |
Oritron | 044 | Wave | 042 |
Panasonic | 020 | Yamaha | 020 |
Philips | 023, 036 | Zenith | 027, 032 |
Pioneer | 022 |
|
|
DVD Player Search Codes Function:
1)Slide the first
2)Press the DVD POWER and RETURN buttons. Hold for at least three seconds and release.
3)Press DVD POWER, see if the DVD player responds.
4)If there was a response, press RETURN. The operating codes are now set. If there was no response, repeat Step 3. If you repeat Step 3 a total of 30 times without a response, use the manufacturers remote control which came with the DVD player.
5)Press RETURN to exit.
10
