Other Features

TV Status

Programme Number, Programme Name (or EXT), (they are displayed on the upper left of the screen). The sound indicator is displayed with them too. They are displayed after programme change for 3 seconds.

Sound Indicator

The alternatives of the indicator are Mono, Stereo, Dual I and Dual II. This indicator is displayed under the programme number indicator on the screen.

￿￿￿￿

In Mono broadcast or in forced-mono (for stereo broad- cast).

￿￿￿￿￿￿

In Stereo broadcast.

￿￿￿￿￿￿￿￿

If dual broadcast detected. Dual I is selected in default and also can be selected after Dual II by Remote Con- trol.

￿￿￿￿￿￿￿￿￿

If Dual II is selected by Remote Control.

Dolby Virtual

By pressing the “ ” button on your remote control, Dolby Virtual effect can be turned on or off.

This function creates a 3-dimensional sound by using 2 existing loudspeakers on your TV set without any additional speakers.

Mute Indicator

It is placed in the upper middle of the screen when en- abled, and it stays there until it is disabled.

To cancel mute, there are two alternatives; the first one is by pressing the “” button, this volume is set to the preceding value, and the second one is increasing or decreasing the volume level.

No-Signal Detection (TV mode)

If no valid signal is detected, it takes 5 minutes to switch to the Stand-By mode unless any signal detected or any Remote Control command is accessed.

After a Remote Control command (if No-Signal Timer is active) the timer stops and if no signal detected again the timer is initialized to 5 minutes and starts 3 seconds later again to count down.

It is not valid in EXT modes.

Volume Bar

It is displayed in the lower middle of the screen. When a volume command is received (pressing “ +” or “ -” by Remote Control or Control panel at the right side of the TV) and no menu is active, it stays on the screen for 3 seconds, after the last volume command or until another command is received in between.

EXT Modes

By pressing the “AV” button you can switch your TV to EXT modes (except being in Teletext). Pressing this button consecutively will switch the TV in one of the optional EXT modes: EXT1, EXT2, EXT2 S and EXT3.

In order to quit the EXT mode press any digit buttons or “” / “”.

Zoom Modes

Zoom mode can be changed by pressing the ZOOM button. You can change the screen size according to the picture aspect ratio. Select the optimum one from the following ZOOM modes.

AUTO:

When a WSS (Wide Screen Signalling) signal, which shows the aspect ratio of the picture, is included in the broadcast signal or the signal from an external device, the TV automatically changes the ZOOM mode to PAN-

ORAMIC.

If a WSS signal is not included, the picture is displayed according to the ZOOM mode set with the 4:3 AUTOASPECT function.

•For details of the 4:3AUTOASPECT function, see page 19.

•When the AUTO mode does not function correctly due to poor WSS signal quality or when you want to change the ZOOM mode, change to another ZOOM mode manually.

Using the different screen formats

Press the ZOOM button to select different modes: Full, Auto, Regular, Panoramic,14:9 Zoom,16:9 Zoom,16:9 Zoom Subtitle modes. In some modes, press “” or “” button to move the picture up or down.

FULL:

This uniformly stretches the left and right sides of a normal picture (4:3 aspect ratio) to fill the wide TV screen.

•For 16:9 aspect ratio pictures that have been squeezed into a normal picture (4:3 aspect ratio), use the FULL mode to restore the picture to its original shape.

- 21 -