JVC CA-MXJ777V, CA-MXJ787V manual Common Operations

English

Common Operations

Setting the Clock Setting the AM Tuner Interval Spacing

Before operating the unit any further, first set the clock built in this unit.

1	Press PANEL OPEN/CLOSE 5.	PANEL
		OPEN / CLOSE
	The unit is turned on and the Powered Rolling Panel
	opens automatically.
2	Press TIMER/CLOCK h.	TIMER
		/CLOCK

The hour digits start flashing on the display.

PRESET

3 Press 4 ; or ¢ ; to adjust the PREV NEXT hour, then press SET k.

SEA CONTROL

• If you want to correct the hour after pressing SET SET

k, press CANCEL /. The hour digits start flashing again.

PRESET

4 Press 4 ; or ¢ ; to adjust the

PREV NEXT

minute, then press SET k.

SEA CONTROL

SET

To adjust the clock again

If you have adjusted the clock before, you need to press TIMER/ CLOCK h repeatedly until the clock setting mode is selected.

•Each time you press the button, the timer/clock setting modes change as follows:

DAILY ON TIME REC

Cancelled Clock ON TIME setting

(The hour digits start flashing.)

If there is a power failure

The clock loses the setting and is reset to “0:00.” You need to set the clock again.

Some countries space AM stations 9 kHz apart, and some countries use 10 kHz spacing.

On the unit ONLY:

You can only change the AM tuner interval spacing while tuning into an AM station.

Press FM/AM u while holding down 7 z.

•Each time you press the button, the AM tuner interval spacing alternates between 9 kHz and 10 kHz.

FM/ AM

NOTE: Preset memory lost when the interval spacing is changed.

Turning On the Power and Selecting the Sources

When you press the play button for a particular source (FM/AM, CD 6, AUX, and TAPE 23), the unit turns on, and the Powered Rolling Panel opens automatically (and the unit starts playing the source if it is ready — COMPU PLAY CONTROL).

To listen to the FM/AM broadcasts, press FM/AM u, Á. (See

page 17.)

To play back CDs, press CD 6y, _. (See pages 10 – 12.) To play back tapes, press TAPE 2 3 7, =. (See page 18.) To select the external equipment as the source, press AUX p, !.

FM/ AM CD TAPE AUX

To turn on the unit without playing, press 2, @ STANDBY

so that the STANDBY lamp goes off.

The Powered Rolling Panel opens automatically.

To turn off the unit (on standby), press	2, @ STANDBY
again so that the STANDBY lamp lights up.
The Powered Rolling Panel also closes.

A little power is always consumed even while the unit is on standby.

To switch off the power supply completely, unplug the AC power cord from the AC outlet.

When you unplug the AC power cord or if a power failure occurs

The clock is reset to “0:00” right away, while the tuner preset stations (see page 17) will be erased in a few days.

7 Continued

EN6-17;MX-J777V/PM67

7/8/99, 9:16 AM