Main Unit
Selecting the Video Signal
ONLY
1Hold
3 Release
2Insert
•If the AM loop antenna wire or speaker cords are covered with vinyl, remove the vinyl to expose the tip of the antenna by twisting the vinyl.
•Make sure the antenna conductors do not touch any other terminals, connecting cords and power cord. Also, keep the antennas away from metallic parts of the System, connecting cords, and the AC power cord. This could cause poor reception.
To connect the speaker cordsConnect the right speaker to the RIGHT terminals, and the left speaker to the LEFT terminals.
1Hold
3 Release
2Insert
When connecting the speaker cords, match the polarity of the speaker terminals:
•For LOW terminals: Red cord to (+) and black cord to
•For HIGH terminals: Grey cord to (+) and blue cord to
• DO NOT connect more than one speaker to each terminal.
•DO NOT allow the conductor of the speaker cords to be in touch with the metallic parts of the System.
When connecting a TV, you can use either one of the video output
After connecting the TV, set the video signal type correctly for your TV.
•Make sure the unit is not yet turned on. If it is already turned on, turn off then on again so that the selector setting becomes active.
VIDEO
OUT
SELECT
Y/C
RGB
Y/C Select for sending
RGB Select for sending the composite video signals or RGB signals through the AV OUT terminal.
Remote
Changing the Scanning Mode | ONLY |
This System supports progressive scanning.
If you connect a progressive TV through the COMPONENT jacks, you can enjoy a high quality picture from the
•If the VIDEO OUT SELECT switch is not set to “Y/C,” this function does not work.
PROGRESSIVE
0PROGRE
INTER
(at the same time)
PROGRE Progressive scanning. For a progressive TV.
INTER Interlaced scanning. For a conventional TV.
6