Before you start

Functional overview (cont’d)

Installing batteries in the remote control Using a remote control

Install two “AA” size batteries (supplied), matching their polarity to those indicated inside battery compartment of the remote control.

123

Note:

Incorrect use of batteries can result in hazards such as leakage and bursting. Please follow the instruction below:

•Do not mix new and old batteries together.

•Do not use different kinds of batteries together. Although they may look similar, different batteries may have different voltages.

•Make sure that the plus and minus ends of each battery match the indications in the battery com- partment.

•Remove batteries from equipment that is not going to be used for a month or more.

•When disposing used batteries, please comply with governmental regulations or public rules for envi- ronmental protection that apply in your country or area.

•Do not recharge, short-circuit, heat, burn or disas- semble batteries.

Keep in mind the following when using the remote control:

•Make sure that there is no obstacle between the remote control and the remote sensor of the unit.

•Remote operation may become unreliable if strong sunlight or fluorescent light is on the remote sensor of the unit.

•Remote control for different devices can inter- fere with each other. Avoid using remote control for other equipment located close to the unit.

•Replace the batteries when you notice a fall-off of the operating range of the remote control.

•The maximum operable ranges from the unit are as follows.

-Beeline: approx. 23 feet (7m)

-Either side of the center: approx. 16 feet (5m) within 30°

-Above: approx. 16 feet (5m) within 15°

-Below: approx. 10 feet (3m) within 30°

Within about 23feet (7m)

 

30˚

Remote

30˚

control

Code: JVC C

 

DISPLAY menu

Press [ON SCREEN] to call up the display menu.This menu will give you the information on the disc. Some operations are available while disc is played back.

41

1

1

0:00:00

DVD-RW

 

 

 

Video mode

 

 

 

CH 8

 

 

 

Stereo

5 2

XP 1:01

1. Indicates a disc type and a format mode.

Note: In some descriptions on this manual, only one disc type is indicated as an example.

2. Indicates a current channel number and an audio status of the program.

3. Indicates a recording mode and possible recording time left.

4. Indicates a title number, chapter number and the time elapsed of disc play.

5. Each icon means:

: Search

:Audio

: Subtitle

:Angle (except VR mode)

: Repeat

: Marker

: Noise Reduction

: Zoom

6. Indicates current disc status.

6 3

Note:

•This is an example screen only for explanation. Displayed items will change depending on the actual mode.

•DISPLAY function is not available when no disc is inserted.

10EN