TROUBLESHOOTING EN 83
●Date and time is not correct.
]Set date and time correctly. ( pg. 20)
●The timer is not engaged.
]Press DVD TIMER (#) and confirm that the DVD timer lamp lights up on the unit.
●Timer recording is in progress.
]Timer programing can’t be performed while a timer recording is in progress. Wait until it finishes.
Timer programing recording does not start.●Date and time is not correct.
]Set date and time correctly. ( pg. 20)
●The timer is not engaged.
]Press DVD TIMER (#) and confirm that the DVD timer lamp lights up on the unit.
●There is a power outage while the DVD deck is in the timer standby mode.
]The unit does not enter timer standby mode automatically when the power is restored to the unit. Engage the timer standby mode again.
VCR Plus+ Timer Programing cannot be made.●Date and time set on the unit is not correct. ]Set date and time correctly. ( pg. 20)
●The channel position does not correspond to that in the receiving area.
]Set the correct channel position for the receiving broadcast. ( pg. 21)
Automatic Satellite Program Recording recording does not start.●The DBS receiver is not connected properly to this unit.
]Connect the DBS receiver to the AUDIO/VIDEO INPUT
●Power failure occurred.
]Set date and time correctly. ( pg. 20)
“PROGRAM FULL” appears on the TV screen during timer programing.●Eight programs have already been timer programed. ]Clear unnecessary programs on the unit, then try timer
programing again. ( pg. 45)
The disc space does not increase when recorded programs are cleared.●The PC’s data recorded on a
Timer programing cannot be made.
●Date and time is not correct.
]Set date and time correctly. ( pg. 20)
●The timer is not engaged.
]Press VCR TIMER (#) and confirm that the VCR timer lamp lights up on the unit.
●Timer recording is in progress.
]Timer programing can’t be performed while a timer recording is in progress. Wait until it finishes.
Timer programing recording does not start.
●Date and time is not correct.
]Set date and time correctly. ( pg. 20)
●The timer is not engaged.
]Press VCR TIMER (#) and confirm that the VCR timer lamp lights up on the unit.
The VCR Timer lamp on the unit won’t stop blinking.●The timer is engaged but there’s no cassette loaded. ]Load a cassette with the record safety tab intact.
●The loaded cassette has had its record safety tab removed. ]Remove the cassette and cover the hole with adhesive tape, or
insert a cassette with the record safety tab intact.
The tape is automatically ejected, then the unit is shut off.●The end of the tape was reached during timer recording.
]The program may not have been recorded in its entirety. Next time make sure you have enough time on the tape to record the entire program.
●The end of the tape was reached during Instant Timer Recording.
]The program may not have been recorded in its entirety. Next time make sure you have enough time on the tape to record the entire program.
VCR Plus+ Timer Programing cannot be made.
●Date and time set on the unit is not correct. ]Set date and time correctly. ( pg. 20)
●The channel position does not correspond to that in the receiving area.
]Set the correct channel position for the receiving broadcast. ( pg. 21)
The VCR Plus+ system does not●The unit’s channel positions have been set incorrectly.
]Refer to “Changing VCR Plus+® Setting” ( pg. 77) and re- perform the procedure.
]Format the disc. (When the disc is soiled, wipe the disc with a soft dry cloth before formatting.) ( pg. 11, 78)