Playback

Remote Control Function

Remote Control A/B/C/D Code Switching

The remote control is capable of controlling four JVC video units independently. Each of the units can respond to one of four codes (A, B, C or D). The remote control is preset to send C code signals because your unit is initially set to respond to C code signals. You can easily modify your unit to respond to A, B or D code signals.

- +

B/``

STANDBY/ON (1/&)

TV

Number 1-4

STOP (x)

ENTER ( )

DVD VIDEO RECORDER

RM-SDR107U

1.Press STANDBY/ON (1/&) on the unit to turn off the unit with no video tape inserted.

2.Press the number key “1” for A, “2” for B, “3” for C or

“4” for D while pressing ENTER ( ) down on the remote control.

3.Press N/`` on the unit for over 5 seconds while the unit is turned off. The current code appears on the display window.

4.Press STOP (x) on the remote control, the current code on the display window changes to new code and blinks for approximately 10 seconds.

5.The new code setup on unit and remote is done.

Note:

If you change the batteries of the Remote Control with A, B or D code, the remote control code is set to C automatically. In this case, you should reset the remote control code described above.

Playing a Tape

1.Press VCR to control the VCR deck.

2.Insert a pre-recorded video cassette.

•If the unit is powered off, it will power on automatically when the tape is loaded.

•If the Timer indicator lights on the front panel display window, press STANDBY/ON once.

3.Press PLAY (N) to start playback.

•If a tape without a safety tab is inserted the unit starts playback automatically.

4.Press STOP (x) to stop playback.

•If the tape reaches the end before you press STOP (x) the Recorder automatically stops, rewinds and ejects the tape.

Note:

S-VHS Quasi Playback (SQPB)

•This Recorder can play back S-VHS recorded tapes, however, it cannot make recordings using S-VHS format tapes.

•SQPB is an abbreviation for S-VHS Quasi Playback.

Playing a DVD

1.Press DVD to control the DVD deck.

2.Press EJECT, OPEN/CLOSE (Z) to open the disc tray. Load your chosen disc in the tray, with the playback side down.

3.Press EJECT, OPEN/CLOSE (Z) to close the tray. Playback starts automatically. If playback does not start, press PLAY (N) or Starts play- back using HOME menu.

4.To stop the playback, press STOP (x).

The unit records the stopped point, depending on the disc. “Xx” appears on the screen briefly. Press PLAY (N) to resume playback (from the scene point). If you press STOP (x) again or unload the disc (“x” appears on the screen.), the unit will clear the stopped point.

5.Press EJECT, OPEN/CLOSE (Z) to remove the disc.

Press EJECT, OPEN/CLOSE (Z) to close disc tray or press STANDBY/ON (1/&), the disc tray closes automatically and unit turns off.

PLAYBACK

23