JVC FS-H10 Using the Timers, Using the Daily Timer, Press TIMER SET, you want the unit to turn on

Using the Timers

Continued

Daily Timer and Sleep Timer are available.

•Before using these timers, make sure the built-in clock is set correctly (see page 8).

Using the Daily Timer

You can set the Daily Timer when the unit is either turned on or in standby mode.

How the Daily Timer actually works

When the on-time comes, the unit automatically turns on and then the off-time comes, the unit automatically turns off (standby).

•Once the timer has been set, it will be activated at the same time everyday until the timer is turned off and the timer setting remains in memory until you change it.

Before you start...

When using “TUNER” as the source to play, make sure to select the desired station before turning off the power.

•In the following procedure, the clock is set to 12-hour system.

•There is a time limit in doing the following steps. If the setting is canceled before you finish, start again from step 1.

3 Press TIMER SET. TIMER SET

The (timer) and the OFF (off-time) indicators flash and the off-time setting appears on the

display.

If you does not need to change the off-time setting, go to step 5.

•If you change the on-time setting, the off-time setting changes to “– –:– –.” You need to set the off-time setting.

4 Press PROGRAM to set the off-time	PROGRAM
you want the unit to turn off.
The hour indication starts flashing on the
display.
1) Press ¢or 4to set the
hour, then press PROGRAM.

2)Press ¢or 4to set the minute, then press PROGRAM.

On the remote control ONLY:

1	Press TIMER SET.	TIMER SET
	The (timer) and the ON (on-time) indicators
	flash and the on-time setting appears on the
	display.
	If you does not need to change the on-time setting, go to
	step 3.

2	Press PROGRAM to set the on-time	PROGRAM
	you want the unit to turn on.

The hour indication starts flashing on the display.

1) Press ¢or 4to set the hour, then press PROGRAM.

2)Press ¢or 4to set the minute, then press PROGRAM.

PROGRAM

5 Press TIMER SET.

The (timer) indicator flashes and the source name appears on the display.

If you does not need to change the source, go to step 7.

6 Press PROGRAM to select the source to play.

The source name starts flashing on the display.

• Press ¢or 4to select “CD” or “TUNER,” then press

PROGRAM.

PROGRAM

TIMER SET

PROGRAM

PROGRAM

18