1If the cords are covered with insulation, remove a short section of insulation at the end of each cord by twisting and pulling it off.
2Press and hold the clamp of the speaker terminal as illustrated.
3Insert the end of the speaker cord into the
terminal.
Match the polarity between the unit and the speaker terminals: ª to ª and · to ·.
4Release your finger from the clamp.
•DO NOT connect speakers while the power is on.
• DO NOT connect more than one speaker to each speaker teminal.
IMPORTANT: Use only speakers with the same speaker impedance as shown on the speaker terminals on the rear of the unit.
To remove the speaker grilles
The speaker grilles are removable.
Holes
Projections
Speaker grille
To remove the speaker grille, insert your fingers at the top
of the speaker grille, pull towards you. Then pull the bottom towards you.
To attach the speaker grille, put the projections of the
speaker grille into the holes of the speaker.
English
Connecting Other Equipment
To connect an audio equipment
You can connect audio
•DO NOT connect any equipment while the power is on.
•DO NOT plug in any equipment until all connections are complete.
Be sure that the plugs of the audio cords are colored: White plugs and jacks are for left audio signals, and red ones for right audio signals.
| R | L |
| AUX |
|
| R |
|
| L |
|
To audio output | L |
|
| Audio equipment |
|
| R |
|
For playing other equipment through this unit, connect
between the audio output jacks on the other equipment and AUX jacks by using audio cords (not supplied).
Now, you are ready to plug in the unit and any other connected equipment.
IMPORTANT: Be sure to check all connections to be done before plugging the AC power cord into a wall outlet.
8
