Using the Tuner
Presetting Stations
You can preset up to 30 FM stations and up to 15 AM sta- tions using the Remote Control.
•Preset numbers may have been set to factory test fre- quencies prior to shipment. This is not a malfunction. You can preset the stations you want into memory by following one of the presetting methods below.
Auto Presetting
In each band, you can automatically preset
AUTO
PRESET (for 2 seconds)
FM/AM
Manual Presetting
| SET |
|
| STORED |
FM/AM | SET | UP | DOWN | SET |
|
|
| or |
|
When changing the |
| FM = 30, AM = 15 |
| |
Band |
|
| ||
1Select a band by pressing the FM/AM button.
2Press the 4 or ¢ button to tune in a station.
3Press the SET button.
“SET” will blink for 5 seconds.
Within 5 seconds, proceed to the next step.
When the display returns to the one set in step 2 after 5 seconds, press the SET button again.
4Press the UP, DOWN, >, or < button within 5 seconds to select the preset number.
UP or DOWN button:Increase or decrease the preset number by 1.
Pressing and holding the button will continuously increase or de- crease the preset number.
> or < button: | Increase or decrease the preset |
| number by 1. |
| Pressing and holding the button |
| will rapidly increase or decrease |
| the preset number. |
5Press the SET button within 5 seconds.
“STORED” appears and after 2 seconds, the display re- turns to the broadcast frequency display.
6Repeat above steps 1 to 5 for each sta- tion you want to store in memory with a preset number.
To change the preset stations, repeat the same
steps as above.
1Select a band by pressing the FM/AM button.
2Press the AUTO PRESET button on the Remote Control for more than two sec- onds.
3Repeat steps 1-2 for the other band.
■If you want to change the preset stations, carry out the Manual Presetting for the desired preset numbers.
CAUTION:
•Even if the system is unplugged or if the power failure occurs, the preset stations will be stored for about 24 hours. However, in case the preset stations are erased, you will need to preset the stations again.
To Change the FM
Reception Mode
When you are tuned into an FM stereo broadcast, the “STEREO” indicator lights up and you can hear stereo ef- fects.
If an FM stereo broadcast is hard to receive or noisy, you can select Monaural mode. Reception improves, but you lose stereo effect.
Press the FM MODE button on the Remote Control so that the “MONO” indicator lights up on the dis- play.
FM MODE
MONO
To restore the stereo effect, press the FM MODE button on the Remote Control so that the “MONO” indicator goes off.
12
