JVC GD V500PZU

Connections

How to connect the SERIAL Terminals

SERIAL

RS-232C cable

D-sub 9p

COMPUTER

The SERIAL terminal is used when the Plasma Display Monitor is controlled by a computer.

53214

Pin layout for RS-232C

Communication parameters

Notes:

(1) Use the RS-232C cable to connect the computer to the Plasma Display Monitor.

(2) The computers shown is for example purposes only.

(3) Additional equipment and cables shown are not supplied with this set.

The SERIAL terminal conforms to the RS-232C interface specification, so that the Plasma Display Monitor can be controlled

by a computer which is connected to this terminal.

The computer will require software which allows the sending and receiving of control data which satisfies the conditions

given below. Use a computer application such as a programming language to software. Refer to the documentation for the

computer application for details.

Command

PON

POF

AUU

AUD

AMT

IIS

DAM

Control details

Power ON

Power OFF

Volume increase

Volume decrease

Mute (toggle)

Input select (toggle)

AV Mode

Component / RGB mode (processed as a

Y/P

or RGB signals as set by this unit)

PC mode

Screen mode select (toggle)

NORMAL (4:3)

ZOOM

FULL

JUST

AUTO

Parameter

None

VID

YP1

RG1

None

NORM

ZOOM

FULL

JUST

SELF

Basic format for control data

The transmission of control data from the computer starts

with a STX signal, followed by the command, the

parameters, and lastly an ETX signal in that order. If there

are no parameters, then the parameter signal does not need

to be sent.

Note:

(1) If multiple commands are transmitted, be sure to wait

for the response for the first command to come from

this unit before sending the next command.

(2) If an incorrect command is sent by mistake, this unit will

send an “ER401” command back to the computer.

STX

Start

(02h)

ETX:C2C1 C3 P2P1 P3P4 P5

Colon Parameter(s)

(1 - 5 bytes) End

(03h)

3-character

command (3bytes)

RS-232C Pin assignment

Pin number

4 • 6

1 • 9

Signal

R X D

T X D

GND

Shorted

Signal level

Synchronization method

Baud rate

Parity

Character length

Stop bit

X parameter

S parameter

RS-232C compliant

Asynchronous

9600 bps

None

8 bits

1 bit

None

Power ON/OFF

Connecting the plug to the Wall Outlet

Push the POWER switch on the Plasma Display Monitor

to turn the set on POWER-ON

Power Indicator: Green

Example: The screen below is displayed for a while after

the Plasma Display Monitor is turned on.

(setting condition is an example.)

When the POWER is turned on for the first time, the

LANGUAGE selection screen is displayed.

From the second time on, language selection can be

done from the setup menu. (see page 21)

Select the desired language using the and keys and

press the store button.

From the second time on, the screen shown below is

displayed for a while (setting condition is an example).

Press the button on the remote control to turn the

Plasma Display Monitor off

Power Indicator: Red (standby)

Press the button on the remote control to turn the

Plasma Display Monitor on

Power Indicator: Green

To turn the power for the Plasma Display Monitor off, press

the switch on the Plasma Display Monitor, when the

Plasma Display Monitor is on or in standby mode.

VIDEO

NORMAL

Remote Control Sensor

INPUT

SURROUND

VOL

OSD LANGUAGE

lish (UK)

Deutsch

Fran ais

Italiano

a ol

ENGLISH (US)

R - STANDBY

G POWER ON

INPUT

–

VOL

R - STANDBY

G POWER ON

Power Indicator

Power ON/OFF and Input Signal Selection

GD-V500PZU