Other external component operations
You can connect an external component to the LINE IN plugs on the rear, and another to the CD changer jack on the rear using the Line Input
•For connection, see Installation/Connection Manual (separate volume).
•For listening to the iPod or D. player, refer to pages 17 and 18.
~
If “EXT IN” does not appear, see page 16 and select the external input (“EXT IN”).
ŸTurn on the connected component and start playing the source.
!Adjust the volume.
⁄Adjust the sound as you want. (See page 14.)
To check the other information while listening to an external component
Clock ÔEXT IN or LINE IN
Maintenance
| How to clean the connectors | ENGLISH |
| ||
Frequent detachment will deteriorate the connectors. |
| |
To minimize this possibility, periodically wipe the |
| |
connectors with a cotton swab or cloth moistened with |
| |
alcohol, being careful not to damage the connectors. |
| |
Connector
Moisture condensation
Moisture may condense on the lens inside the unit in the following cases:
•After starting the heater in the car.
•If it becomes very humid inside the car.
Should this occur, the unit may malfunction. In this case, eject the disc and leave the unit turned on for a few hours until the moisture evaporates.
How to handle discs
When removing a disc from its | Center holder |
case, press down the center holder of |
|
the case and lift the disc out, holding |
|
it by the edges. |
|
• Always hold the disc by the edges. Do not touch its recording surface.
When storing a disc into its case, gently insert the disc around the center holder (with the printed surface facing up).
• Make sure to store discs into the cases after use.
Continued on the next page
19
