KD-S15
CD RECEIVER: INSTRUCTIONS/INSTALLATION
[J]
ENGLISHESPAÑOL
INFORMATION (For U.S.A.)This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–Reorient or relocate the receiving antenna.–Increase the separation between the equipment and receiver.–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–Consult the dealer or an experienced radio/TV technician for help.Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit.
Installation/connection are explained at the last section of this manual (reverse page, indicated with symbol).
For customer Use:Enter below the Model No. and Serial No. which are located on the top or bottom of the cabinet. Retain this information for future reference.
Model No. | 0508DTSMDTJEIN |
Serial No. | EN |
| © 2008 Victor Company of Japan, Limited |
|
MAINTENANCE
How to clean the connectors | To keep discs clean |
Wipe the connectors with | Wipe in a straight line from center of disc to |
a cotton swab or cloth | edge. Do not use liquid cleaners, thinners, or |
moistened with alcohol. | benzene. |
| Connectors |
Moisture condensation | To play new discs |
Moisture may condense on the lens inside the unit. Eject | Remove any rough areas from the inner and |
the disc and leave the unit turned on for a few hours until | outer edges of the disc. |
the moisture has evaporated. |
|
Changes or modifications not approved by JVC could void the user’s authority to operate the equipment.
IMPORTANT FOR LASER PRODUCTS1.CLASS 1 LASER PRODUCT2.CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel.
3. | CAUTION: (For U.S.A.) | Visible and/or invisible class II laser radiation when open. Do not stare into beam. |
| (For Canada) | Visible and/or invisible class 1M laser radiation when open. Do not view directly with optical |
|
| instruments. |
4. | REPRODUCTION OF LABEL: CAUTION LABEL, PLACED OUTSIDE THE UNIT. |
For safety... | Warning | |
• | Do not raise the volume level too much, as this will block | If you need to operate the unit while driving, be sure to |
| outside sounds, making driving dangerous. | look around carefully or you may be involved in a traffic |
• | Stop the car before performing any complicated | accident. |
| operations. |
|
Temperature inside the car... | Caution on volume setting |
If you have parked the car for a long time in hot or cold | Discs produce very little noise compared with other sources. |
weather, wait until the temperature in the car becomes | Lower the volume before playing a disc to avoid damaging |
normal before operating the unit. | the speakers by the sudden increase of the output level. |
MORE ABOUT THIS UNIT
Single | Warped disc | Sticker and sticker residue |
|
| Transparent or |
Unusual shape | parts on its recording area |
PREPARATIONS
How to reset your unit | Detaching the control panel |
• Your preset adjustments will also be erased. | Attaching the control panel |
• Be careful not to drop the disc when it ejects. |
Basic operations
•By pressing SRC on the unit, you can also turn on the power. If the source is ready, playback also starts.
•If you turn off the power while listening to a disc, disc play will start from where it had been stopped previously next time you turn on the power.
•When no disc is loaded in the unit, you cannot select “CD” as the playback source.
Tuner operations
•During SSM search...–All previously stored stations are erased and the stations are stored anew.–Received stations are preset in No. 1 (lowest frequency) to No. 6 (highest frequency).
–When SSM is over, the station stored in No. 1 will be automatically tuned in.Disc operations
Caution for DualDisc playback•The
•This unit has been designed to reproduce CDs/CD Texts, and
•After ejecting a disc, “NO DISC” appears and you cannot operate some of the buttons. Insert another disc or press SRC to select another playback source.
Playing a•This unit can play back
–There are improper recording conditions (missing data, etc.) or media conditions (stained, scratched, warped, etc.).
•
• If this does not work, reset your unit. |
Enter PSM menu. | Cancel the display | Set the clock |
| demonstration |
|
Deactivate the display | Adjust the hour. | Adjust the minute. |
demonstration. |
|
|