JVC GR-AX920 manual Tape remaining time indicator, Power, Start/Stop button, Tally lamp

•The camcorder re-enters the Record-Standby mode.

Press the Start/Stop button.

•The tally lamp lights while recording is in progress, and “REC ” appears in the viewfinder.

STOP RECORDING

START SHOOTING

3

NOTE:

14RECORDING Basic Recording

Tape remaining time indicator

25min	*---min	You should already have performed the procedures listed
		below. If not, do so before continuing.
	(Now calculating)
		● Power (☞ pg. 8)
	120min	● Date/Time Setting (☞ pg. 11)
		● Tape Length setting (☞ pg. 12)
	119min	● Recording Mode Setting (☞ pg. 12)
		● Grip Adjustment (☞ pg. 13)
Power indicator	3min	LOAD A CASSETTE
	2min (Blinking)	Slide EJECT to open the cassette holder, then insert
		1 the cassette with the label facing out. Press PUSH to
	1min (Blinking)	ensure the holder is closed and locked.
		ENTER RECORD–STANDBY MODE
	0min (Blinking)
		Slide the LENS COVER open/close switch to open
		2 the lens cover, then set the power switch to
		“CAMERA”.
		•The power indicator lights and the camcorder
	LENS COVER	enters the Record–Standby Mode.
		•The scene you’re aimed at appears on the
	switch	viewfinder screen, with the word “PAUSE”
		superimposed upon it.

POWER

Start/Stop button

4 Press the Start/Stop button again to stop recording.

Tally lamp

NOTES:

●A cassette holder can’t be opened unless a power supply is attached.

●There may be a delay after you slide EJECT until the holder opens. Do not use force.

●The tape’s remaining time is displayed in the viewfinder as shown.

●The indicated remaining time is approximate.

●The time required to calculate the remaining tape length, and the accuracy of the calculation, may vary according to the type of tape used.

●The tape remaining time displayed in the viewfinder is correct only if the correct tape length has been selected (☞ pg. 12).

●“TAPE END” appears when the tape reaches its end, and the power goes off automatically if left in this condition for 5 minutes. “TAPE END” also appears when a cassette whose tape is already at its end is loaded.

●If the Record–Standby mode continues for 5 minutes without performing Zoom or any other operations, the camcorder’s power shuts off automatically. Set the Power switch to “POWER OFF”, and then back to “CAMERA” to turn the camcorder on again.

●If the Recording Start/Stop button is pressed after the Record-Standby mode has continued for over 5 minutes, recording may not start immediately.

●If you’re recording on a cassette from the middle, use the RETAKE function (☞ pg. 15) to find the end of the last recording so you don’t erase any of it.

●The LENS COVER warning blinks for about 10 seconds when the camcorder is turned on, when the cover is closed.