JVC GR-AX96 manual Interval Timer Indicator, Far

CLOSE MENU

3 Press MENU.

START DELAYED RECORDING

4 Press RECORDING START/STOP. The tally lamp begins blinking, and the blinking frequency increases about 5 seconds before recording is to start. Once recording begins, the lamp stops blinking but stays lit.

To Release Self-Timer . . .

..... while the tally lamp is blinking, press RECORDING

START/STOP to stop the blinking, then set “Interval Timer” to “OFF”.

SET INTERVAL TIME

Turn the PROGRAM AE select dial to any position except AUTO LOCK, then press MENU.

1

2 Press – or + to move the highlight bar down to “Interval Timer”, then press FAR or NEAR to cycle through the choices. Stop when the desired time appears. Choose from “15s”, “30s”, “1min”, “5min”, or select to turn the function “OFF”.

NOTE:

Make sure the camcorder is in the Record-Standby mode before performing the following steps.

ACCESS MENU SCREEN

NEAR

MENU

Self-Timer

You can set the delay between pressing RECORDING START/STOP and the actual start of recording. If you secure the camcorder, you (or whomever is operating the camcorder) can enter the scene before recording starts.

1min

Advanced Features (cont.)

30RECORDING

Interval

Timer Indicator

Rec Time Indicator 1/2s

+

FAR –

Tally lamp

Gain Up	S . LX
Tele Macro	OFF
Interval Timer	OFF
Rec Time	OFF
JLIP ID NO .	07
Tally	ON
Set Character
Date/Time
END :MENU KEY

5s 1s 1/2s 1/4s OFF

5min 1min 30s 15s OFF