Using Your Kambrook Heater continued
NOTE: There is a
Setting the Oscillation
This function will work in any mode. Pressing the ‘SWING’ button will allow the heater to oscillate side to side. To stop the unit oscillating, press the ‘SWING’ button once more.
Setting the Auto-Off Timer
The timer function works in all operating modes and switches the unit off after a preset number of hours.
•Select the desired setting.
•Press the ‘TIMER’ button to activate the timer settings.
•Press the ‘TIMER’ button to cycle through in 0.5 hour increments, up to 8 hours.
•Once the TIMER is set to the desired set time, the TIMER will count down in 0.5 hour increments, showing on the LCD screen the remaining operating time. The heater will then switch itself to standby mode with no heat output after the selected number of hours has passed.
Setting the Variable
Temperature
The variable temperature can be used to maintain your desired room temperature.
NOTE: The variable temperature only operates when the heater is set to AUTO mode.
1.Press the ‘MODE’ button until the heater is set to AUTO mode.
2.To adjust the temperature settings, press the ‘TEMPERATURE’ (+) button to increase and
3.When the air temperature reaches
4.When the air temperature drops below the set temperature, to maintain set temperature the unit will begin heating again.
Using the Remote Control
The remote control buttons operate in the same way as those on the heater control panel. Your remote control requires 2 x “AAA” batteries and can be conveniently stored in the compartment on the rear housing of the heater (please note batteries are not included). Ensure the remote has uninterrupted line of sight to the remote control signal receiver.
10
KCE340_IB_A12.indd 10 | 2/11/12 11:37 AM |