Using Your Kambrook Heater
Before First Use
Remove your heater from its carton and associated protective wrapping.
Unwind the cord to its full length and remove any protective cardboard or foam that may have been used to minimise transportation damage. Place the heater on a firm, level surface in a stable upright position.
Visually inspect the air inlet and outlets to ensure no foreign material is blocking these areas. The heater must always be operated with the rear air filter in position.
Turning Your Heater On
Plug the cord into a 230V or 240V electrical outlet. Be sure the plug fits tightly as a loose fit will cause overheating and damage the plug.
NOTE: To avoid an electrical circuit overload, it is recommended that no other appliances are plugged into the same circuit with your heater when you switch the unit on.
Turn the heater on by pressing the main power ‘ON/OFF’ switch, located at the base of the heater, to the ‘ON’ position; the heater will “beep” once and the LCD display screen will illuminate for at least 30 seconds indicating that the power is on and in standby mode.
To start the heater working, press the ‘POWER’ button once; the unit will be in HIGH heat mode (2000 watts). The LCD screen will display the current room temperature.
Pressing the ‘MODE’ button once will set the heater into the AUTO mode. AUTO mode allows the heater to maintain the desired set room temperature. In this setting, the heater will automatically cycle on and off to maintain temperature (see page 10 under Setting the Variable Temperature).
Pressing the ‘MODE’ button twice will set the heater into the FAN mode, and the LCD screen will only show the current room temperature.
NOTE: FAN mode is for
Pressing the ‘MODE’ button three times will cause the heater to go into the LOW heat mode (1000W).
To turn the heater OFF, press the ‘POWER’ button once. Turn the main power ‘ON/OFF’ switch to the ‘OFF’ position and turn off at the power outlet and remove the plug from the power outlet.
NOTE: Once the ‘POWER’ button to turn the heater OFF is selected, the fan may continue to run for approximately 30 seconds to cool the heater. Always wait for the fan to stop cooling the heater before switching off the main power ‘ON/OFF’ switch located at the base of the heater, then turn the unit off at the power outlet.
9
KCE340_IB_A12.indd 9 | 2/11/12 11:37 AM |