JVC GR-AX999UM, LYT0108-001A manual REW Power Switch Viewfinder, START/STOP REW Play Pause Insert

RESET COUNTER

3 Press and hold COUNTER R/M for more than

1 second to reset the tape counter, then press again for less than 1 second and make sure “M” appears.

FIND EDIT-IN POINT

4 Press REW to go a little beyond the beginning of the scene you want to replace, press PLAY to view the recorded tape, and press PAUSE exactly at the point where the new scene should start.

ENGAGE INSERT EDITING MODE

5 Press and hold INSERT, and without releasing INSERT, press and release PAUSE. The Insert mode is engaged. When the scene the camcorder is aimed at appears on the screen, go to the next step.

BEGIN INSERT EDITING

6 Press START/STOP. When the counter reaches “0:00:00”, editing stops automatically and the camcorder enters the Insert-Pause mode.

END INSERT EDITING

7 Press STOP.

NOTES:

FIND EDIT-OUT POINT

Set the System Select Switch to “VIDEO”, then set the Power Switch to “PLAY”.

1

2 Play back the tape, locate the Edit-out point and press PAUSE on the camcorder or the remote control.

STOP

Use the RM-V705U or RM-V700U remote control unit to perform this procedure.

SELECT MODE

FF

Insert Editing (VIDEO)

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

USING REMOTE CONTROL UNIT

(cont.)

68EN

COUNTER R/M

PLAY/PAUSE

REW

Power Switch

Viewfinder

Insert editing indicator

M–0:12:34 Tape Counter

System Select Switch

START/STOP

REW

PLAY

PAUSE

REW

INSERT

RM-V700URM-V705U

(optional) OR (provided)

●After step 5, Retake (☞ pg. 21) can be performed.

●The tape may stop slightly before or after the designated end point, and noise bars may appear. Neither indicates a defect in the unit.

●Only video signal is recorded in the Insert Editing mode.