52EN

D.S.C.PLAYBACKBasicPlayback

System

Select Switch

Power lamp

Power Switch

To move

the page next

Display

Still images shot using this camcoder are automatically numbered, then stored in numerical order in the built-in memory. You can view the still images stored in memory, one at a time, much like flipping through a photo album.

1 SELECTMODE OPERATION SYSTEM AND

Set the System Select Switch to “D.S.C.”, and set the Power Switch to “PLAY”.

•The power lamp lights.

•The still image stored in memory is displayed. •When no still image is stored in memory, the screen

becomes blue.

2 PLAY BACK

Press FF (3/PAGE+) or REW (2/PAGE–) to select the still image you want to view.

•Each time REW (2/PAGE–) is pressed, the page goes back, while each time FF (3/PAGE+) is pressed, the page goes next.

•Even if you shoot a new picture after playing back a still image with a low number, this will not overwrite the existing picture because new pictures are automatically stored after the still image most recently stored in memory.

NOTES:

When the Power Switch is set to “PLAY” and the LCD monitor is opened at an angle of 60 degrees or more, the LCD monitor switches on and the viewfinder switches off automatically to save power.

The playback picture can also be viewed in the

viewfinder (with the LCD monitor shut) or on a connected TV (pg. 50). Camcorder operation is the same as described in this section.

When viewing a playback picture on a connected TV, it may jitter slightly.

You can also view the playback picture on the LCD monitor with it flipped over and retracted.

To move

the page back

Page 52
Image 52
JVC GR-AXM710 manual C. Playback Basic Playback, Becomes blue, To move Back