44 EN EDITING

 

Dubbing To A Video Unit Equipped

NOTES:

With A DV Connector (Digital

● It is recommended to use the AC Adapter as

the power supply instead of the battery pack.

Dubbing)

( pg. 14)

● If a blank portion or disturbed image is played

It is also possible to copy recorded scenes from

back on the player during dubbing, the dubbing

may stop so that an unusual image is not dubbed.

the camcorder onto another video unit equipped

● Even though the DV cable is connected correctly,

with a DV connector. Since a digital signal is

sometimes the image may not appear in step 4. If

sent, there is little if any image or sound

this occurs, turn off the power and make

deterioration.

connections again.

 

● If “Playback Zoom” ( pg. 24) or “Playback

 

Special Effects” ( pg. 24) is attempted or

 

SNAPSHOT is pressed during playback, only the

 

original playback image recorded on the tape is

 

output from the DV OUT connector.

 

● When using a DV cable, be sure to use the

 

optional JVC VC-VDV204U DV cable.

To DV OUT

 

Core filter

DV cable (optional)

 

To DV IN

Video unit equipped with DV connector

1 Make sure all units are turned off.

2 Connect this camcorder to a video unit equipped with a DV input connector using a DV cable as shown in the illustration.

3 Start playback on the camcorder. ( pg. 20)

4 At the point you want to start dubbing, start recording on the video unit. (Refer to the video unit’s instruction manual.)

5 To stop dubbing, stop recording on the video unit, then stop playback on this camcorder.