TROUBLESHOOTING EN 35
If, after following the steps in the chart below, the |
| The LCD monitor or viewfinder indications |
problem still exists, please consult your nearest |
| |
| blink. | |
JVC dealer. |
| |
| ● Effect and “DIS” functions that cannot be used | |
|
| |
|
The camcorder is a |
| together are selected at the same time. | ||
device. External noise and interference (from a |
| ➜ | ||
TV, a radio, etc.) might prevent it from |
| ( pg. 22, 23, 31) | ||
functioning properly. In such cases, first |
|
|
| |
| Digital Zoom does not work. |
| ||
disconnect its power supply unit (battery pack, |
|
| ||
AC Adapter, etc.) and wait a few minutes; and |
| ● 28X optical zoom is selected. | ||
then |
| ➜ Set “ZOOM” to “56X” or “800X”. ( pg. 24) | ||
the beginning. |
| Video Playback | ||
|
|
| ||
Power |
| |||
|
|
| ||
|
|
| ||
|
|
| The tape is moving, but there is no picture. |
|
|
| |||
|
|
|
|
|
No power is supplied.
●The power is not connected properly.
➜ Connect the AC Adapter securely. ( pg. 13) ● The battery pack is not attached firmly.
➜ Detach the battery pack once again and
it firmly. ( pg. 12)
●The battery is dead.
➜Replace the dead battery with a fully charged one. ( pg. 13)
Video Recording
Recording cannot be performed.
●The tape’s erase protection tab is set to “SAVE”. ➜ Set the tape’s erase protection tab to “REC”.
( pg. 16)
●“TAPE END” appears.
➜ Replace with new cassette. ( pg. 16) ● The cassette holder cover is open.
➜ Close the cassette holder cover.
When shooting a subject illuminated by bright light, vertical lines appear.
●This is not a malfunction.
When the screen is under direct sunlight during shooting, the screen becomes red or black for an instant.
●This is not a malfunction.
●Your TV has AV input terminals, but is not set to its VIDEO mode.
➜ Set the TV to the mode or channel appropriate for video playback. ( pg. 22)
●The cassette holder cover is open.
➜ Close the cassette holder cover. ( pg. 16)
Blocks of noise appear during playback, or there is no playback picture and the screen becomes blue.
➜ Clean the video heads with an optional cleaning cassette. ( pg. 40)
Advanced features
The focus does not adjust automatically.
●Focus is set to the Manual mode.
➜ Set Focus to the Auto mode. ( pg. 27)
●The lens is dirty or covered with condensation. ➜ Clean the lens and check the focus again.
( pg. 38)
Snapshot mode cannot be used.
●The16:9 wide mode ( 
16:9 indicator) is selected.
➜ Disengage the ( 
16:9 indicator) 16:9 wide mode. ( pg. 26)
REFERENCES
During recording, the date/ time does not appear.
●“DATE/TIME” is set to “OFF”.
➜ Set “DATE/TIME” to “ON”. ( pg. 22, 24)
