16 EN GETTING STARTED
Tripod Mounting |
| To protect valuable recordings | |
| Slide the erase protection tab on the back of the | ||
To attach the camcorder |
| tape in the direction of “SAVE”. This prevents the | |
| tape from being recorded over. To record on this | ||
to a tripod, align the |
| ||
| tape, slide the tab back to “REC” before loading | ||
direction stud and screw |
| ||
| it. | ||
to the mounting socket |
| ||
|
| ||
and stud hole on the |
| NOTES: | |
camcorder. Then tighten |
| ● If you wait a few seconds and the cassette holder | |
the screw clockwise. |
| does not open, close the cassette holder cover | |
● Some tripods are not |
| and try again. If the cassette holder still does not | |
equipped with studs. |
| open, turn the camcorder off then on again. | |
Loading/Unloading A Cassette | ● If the tape does not load properly, open the | ||
cassette holder cover fully and remove the | |||
|
| ||
|
| cassette. A few minutes later, insert it again. | |
The camcorder needs to be powered up to load | ● When the camcorder is suddenly moved from a | ||
cold place to a warm environment, wait a short | |||
or eject a cassette. |
| ||
| time before opening the cassette holder cover. | ||
OPEN/EJECT | Cassette holder | ||
| |||
PUSH | cover |
| |
|
| ||
Cassette holder | Erase |
protection tab |
Make sure the window side is facing out.
1 Slide and hold OPEN/EJECT in the direction of the arrow, then pull the cassette holder cover open until it locks. The cassette holder opens automatically.
÷Do not touch internal components.
2 Insert or remove a tape and press “PUSH” to close the cassette holder.
÷Be sure to press only the section labelled “PUSH” to close the cassette holder; touching other parts may cause your finger to get caught in the cassette holder, resulting in injury or product damage.
÷Once the cassette holder is closed, it recedes automatically. Wait until it recedes completely before closing the cassette holder cover.
÷When the battery pack’s charge is low, you may not be able to close the cassette holder cover. Do not apply force. Replace the battery pack with a fully charged one or use AC power before continuing.
3 Close the cassette holder cover firmly until it locks into place.
