|
| TROUBLESHOOTING | EN 31 |
Warning Indications |
|
| |
|
| ||
| E01, E02 or E06 | ||
|
| UNIT IN SAFEGUARD MODE REMOVE AND | |
| |||
|
| REATTACH BATTERY | |
|
|
|
|
Displays the battery remaining power.
Remaining power level
High | Exhausted |
As the battery power comes close to nil, the battery indicator blinks.
When the battery power is exhausted, power turns off automatically.
Appears when no tape is loaded. ( pg. 9)
CHECK TAPE’S ERASE PROTECTION TAB
Appears when the erase protection tab is set to “SAVE” while the Power Switch is set to “A” or “M”. ( pg. 8)
USE CLEANING CASSETTE
Appears if dirt is detected on the heads during recording. Use an optional cleaning cassette. ( pg. 33)
CONDENSATION, OPERATION PAUSED
PLEASE WAIT
Appears if condensation occurs. (The two indications above swiches alternately every 3 seconds.) When this indication is displayed, wait more than 1 hour until condensation disappears.
The error indications (E01, E02 or E06) show what type of malfunction has occurred. When an error indication appears, the camcorder turns off automatically. Remove the power supply (battery, etc.) and wait a few minutes for the indication to clear. When it does, you can resume using the camcorder. If the indication remains, consult your nearest JVC dealer.
E03 or E04
UNIT IN SAFEGUARD MODE EJECT AND REINSERT TAPE
The error indications (E03 or E04) show what type of malfunction has occurred. When an error indication appears, the camcorder turns off automatically. Eject the cassette once and
TAPE!
Appears if a tape is not loaded when the Recording Start/ Stop Button or SNAPSHOT Button is pressed while the Power Switch is set to “A” or “M”.
TAPE END
REFERENCES
Appears when the tape ends during recording or playback. ( pg. 27)
SET DATE/TIME!
●Appears when the date/time is not set. ( pg. 8)
●Appears when the
LENS CAP
Appears for 5 seconds after power is turned on if the lens cap is attached.
COPYING FAILED
●Appears if dubbing of copyguarded signals is attempted while this camcorder is being used as a recorder.
