The audio track can be customized only when recorded in the
NOTES:
●Audio Dubbing is not possible on a tape recorded in
●To perform Audio Dubbing while watching on the television, make connections ( pg. 15).
1 Play back the tape to locate the point where editing will start, then press PAUSE (6) T.
2 While holding A.DUB (e) j on the remote control, press PAUSE (6) T. “6e” y and “MIC”
3 Press PLAY (4) h, then begin “narrating”. Speak into the microphone.
•To pause dubbing, press PAUSE (6) T.
4 To end Audio Dubbing, press PAUSE (6) T, then STOP (5) O.
To hear the dubbed sound during playback . . ...... set “12BIT MODE” to “SOUND 2” or “MIX” in the
Menu Screen ( pg. 25).
NOTES:
●Sound is not heard from the speaker during Audio Dubbing.
●When editing onto a tape that was recorded at
●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.
●If feedback or howling occurs during TV playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.
●If you change from
●During Audio Dubbing, when the tape moves to scenes
recorded in the LP mode, scenes recorded in
●To perform Audio Dubbing with a video unit connected to
the camcorder’s AV connector, first set “S/AV INPUT” to “ON” in the Menu Screen
You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in and outpoints. The original audio remains unchanged.
NOTES:
●Before performing the following steps, make sure that
“TIME CODE” is set to “ON” in the Menu Screen ( pg. 24, 25).
●Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.
●To perform Insert Editing while watching in the television, make connections ( pg. 15).
1 Play back the tape, locate the
2 Press REW (2) U until the
3 Press and hold INSERT (w) I on the remote control, then press PAUSE (6) T. “6w” & and the Time Code (min.:sec.) appear and the camcorder enters
4 Press START/STOP a to begin editing.
•Confirm the insert at the time code you checked in step 1.
•To pause editing, press START/STOP a. Press it again to resume editing.
5 To end Insert Editing, press START/STOP a, then STOP (5) O.
NOTES:
●Programme AE with special effects ( pg. 16) can be used to spice up the scenes being edited during Insert Editing.
●During Insert Editing, the date and time information changes.
●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.
●During Insert Editing, when the tape moves to scenes
recorded in the LP mode or a blank portion, Insert Editing stops ( pg. 44).
|
|
| W |
|
|
|
| E |
|
|
| a |
|
R | T | 9 | 6 | 0 | d s | |
Y | U | 2 | 4 | 3 | g | f |
I | O | w | 5 | e | j | h |
P |
|
|
| k | ||
| T |
| l | |||
|
|
| ||||
|
| W |
|
|
;
Stereo microphone
EN