JVC GR-DF550 Power, Charging The Battery Pack, How To Attach The Core Filter, mark, Arrow, Stopper, Wind once, AC Adapter, Core filter, Battery pack, DC connector

Connect the AC Adapter to the camcorder.

		GETTING STARTED	EN 13
How To Attach The Core Filter
		Power
Attach the core filters to the cables. The core
	This camcorder’s 2-way power supply system
filter reduces interference.
	lets you choose the most appropriate source of
1 Release the stoppers on both ends of the
	power. Do not use provided power supply units
core filter.	with other equipment.

Charging The Battery Pack

Stopper

2 Run the cable through the core filter, leaving approx. 3 cm (1-3/16") of cable between the

BATT. RELEASEBattery pack

Open the cover.

cable plug and the core filter.

Wind the cable once around the outside of the core filter as shown in the illustration.

Core filter

3 cm (1-3/16") Wind once.

3 Close the core filter until it clicks shut.

NOTES:

●Take care not to damage the cable.

●When connecting a cable, attach the end with the core filter to the camcorder.

To

DC connectorArrow

Battery pack mount mark

Power switch

POWER/CHARGE lamp

AC AdapterTo AC outlet

1 Set the Power Switch to “OFF”.

2 With the arrow on the battery pack pointing right, push the battery pack slightly against the battery pack mount a.

3 Slide the battery pack to the right until it locks in place b.

4

5 Plug the AC Adapter into an AC outlet. The POWER/CHARGE lamp on the camcorder blinks to indicate charging has started.

6 When the POWER/CHARGE lamp goes out, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

GETTING STARTED

CONTINUED ON NEXT PAGE