VIDEO RECORDING |
| EN 17 | |
| Basic Recording | 4 Set the Power Switch to “A” or “M” while | ||
pressing down the Lock Button located on the | |||
NOTE: | switch. | ||
● The power lamp lights and the camcorder | |||
Before continuing, perform the procedures listed |
| enters the | |
below: |
| displayed. | |
5 To start recording, press the Recording Start/Stop | |||
Button. The tally lamp lights and “T REC” | |||
Power Lamp | |||
appears on the display while recording is in | |||
Power Zoom Lever | progress. | ||
| 6 To stop recording, press the Recording Start/Stop | ||
| Button again. The camcorder | ||
| |||
| NOTES: | ||
| ● The image will not appear simultaneously on the | ||
| LCD monitor and the viewfinder. | ||
| ● If the | ||
Power Switch | 5 minutes, the camcorder’s power shuts off | ||
| automatically. To turn the camcorder on again, | ||
| push back and pull out the viewfinder again or | ||
Lock Button | close and | ||
Recording Start/Stop Button | ● LCD monitor/viewfinder indications: | ||
| • When power is supplied from a battery: the | ||
VIDEO/MEMORY Switch | “ | ||
• When power is supplied from an AC outlet: the | |||
| |||
| “ | ” battery indicator does not appear. | |
| ● When a blank portion is left between recorded | ||
| scenes on the tape, the time code is interrupted | ||
| and errors may occur when editing the tape. To | ||
| avoid this, refer to “Recording From The Middle | ||
| |||
| ● To turn the tally lamp or beep sounds off, | ||
Tally Lamp | |||
(Lights while recording is in | ● To record in LP (Long Play) mode, pg. 31, 34. | ||
progress.) INFO LCD | ● For other notes, pg. 67. | ||
PUSH OPEN Button
INFO LCD Indications
1Remove the lens cap.
2Press PUSH OPEN and open the LCD monitor fully, or pull out the viewfinder fully.
1 2 3
aTape indicator(Appears when a cassette is loaded and blinks when no cassette is loaded.)
bRecording timecBattery indicator●To turn off the indications, pg. 31, 38.
3Set the VIDEO/MEMORY Switch to “VIDEO”.