JVC GR-DVF25 manual Power lamp blinks There are disturbances in audio, Recommended to charge it

62EN

TROUBLESHOOTING(cont.)

SYMPTOM

37.The charge indicator on the AC Power Adapter/ Charger does not light.

38.The recording mode indicator “LP” blinks.

39.Picture does not appear on the LCD monitor.

40.Picture does not appear in the viewfinder.

41.When the image is printed from the printer, a black bar appears at the bottom of the screen.

42.The power lamp blinks.

43.There are disturbances in audio.

POSSIBLE CAUSES	CORRECTIVE ACTION
37. •The temperature of the	37. • To protect the battery, it is
battery is extremely high/low.	recommended to charge it in
•Charging is difficult in places	places with a temperature of
subject to extremely high/low	10°C to 35°C (☞ pg. 69).
temperatures.
38. •This occurs when recording	38.
in the LP mode is not
available. After the indicator	————
blinks, the recording mode
switches to “SP” and
recording goes on.
39. •The lens cover is closed.	39. • Open the lens cover
•The LCD monitor is not open	(☞ pg. 14).
at an angle of over 60	• Open the LCD monitor to an
degrees.	angle of over 60 degrees.
•The LCD monitor’s brightness	• Adjust the brightness of the
setting is too dark.	LCD monitor (☞ pg. 17).
	• If the monitor is tilted
	upward to 180 degrees,
	open the monitor fully
	(☞ pg. 17).
40. •The lens cover is closed.	40. • Open the lens cover
•The LCD monitor is open.	(☞ pg. 14).
•If the LCD monitor is not	• Close the LCD monitor.
facing forward towards the	• Open the LCD monitor and
subject, Interface Shooting	tilt it upward 180 degrees so
will not be possible.	that it faces forward
	(☞ pg. 17).
41. •This is not a malfunction.	41. • By recording with Picture
	Stabilizer activated
	(☞ pg. 18) this can be
	avoided.
42. •The camcorder was turned	42. • Replace with a charged
on when the battery power	battery pack (☞ pg. 6)
was almost gone.
43. •If Audio Dubbing has	43. • Use a new, or infrequently
been performed	used, tape for Audio
repeatedly on the same	Dubbing (☞ pg. 56, 57).
portion of the tape,
disturbance to the sound
may result.