38 EN
Video unit equipped
with DV output
connector
To DV OUT
To DV IN
Power Switch
Core filter
DV cable
(optional)

Dubbing From A Video Unit Equipped With

A DV Connector (Digital Dubbing)

[To use this camcorder as a recorder]

1
Make sure all units are turned off. Connect the
camcorder to a video unit equipped with a DV output
connector using a DV cable as shown in the
illustration.
2
Set “REC MODE” to “SP” or “LP” in the Menu Screen
depending on your preference ( pg. 11 or 30).
3
Set this camcorder’s Power Switch to “ ” while
pressing down the Lock Button located on the switch.
Turn on the video unit’s power and insert the
appropriate cassettes in the camcorder and the video
unit.
4
Press the Recording Start/Stop Button on the
camcorder to engage the Record-Pause mode.
“DV. IN” appears on the screen.
5
Engage the video unit’s Play mode, then engage the
Still Playback mode when you have found a spot just
before the edit-in point.
6
Press the Recording Start/Stop Button on the
camcorder to engage the Record mode. “
DV. IN
”
appears on the screen. Engage the video unit’s Play
mode.
7
To stop dubbing, press the Recording Star/Stop Button
on the camcorder so that “DV. IN” reappears, then
engage the video unit’s Stop mode.
8
Repeat steps 5 through 7 for additional editing.
NOTES:
●
It is recommended to use the AC Power Adapter/Charger as the power supply instead of the battery pack
(
pg. 7).
●
If the remote control is used when both the player and recorder are JVC video units, both units will perform
the same operation. To prevent this from happening, press the buttons on both units.
●
For Digital Dubbing, this camcorder can be connected only to one device at a time.
●
If a blank portion or disturbed image is played back on the player during dubbing, the dubbing may stop so
that an unusual image is not dubbed.
●
Even though the DV cable is connected correctly, sometimes the image may not appear in step 5. If this
occurs, turn off the power and make connections again.
●
Digital Dubbing is performed in the sound mode recorded on the original tape, regardless of the current
“SOUND MODE” setting (
pg. 21).
●
During Digital Dubbing, no signals are output from the video or audio connectors.
●
When using a DV cable, be sure to use the optional JVC VC-VDV204U DV cable.
DUBBING
(cont.)
Connector cover*
*When connecting the cable, open this cover.