JVC GR-DVL30 specifications 48 EN, Audio Dubbing

48EN

USINGTHEREMOTECONTROLUNIT(cont.)

Display

Audio Dub Standby mode

Power Switch

Speaker

Remote sensor

Audio Dubbing

The audio track can be customized only when recorded in the 32 kHz mode (☞ pg. 20).

NOTES:

●Audio Dubbing is not possible on a tape recorded at 48 kHz, on a tape recorded in the LP mode or on a blank portion of a tape.

●To perform Audio Dubbing while watching on the television, make connections (☞ pg. 32).

1 Play back the tape to locate the point where editing will start, then press PAUSE (6).

2 While holding A.DUB (e) on the remote control, press PAUSE (6). “6e” appears.

3 Press PLAY (4) , then begin “narrating”. Speak into the microphone.

•To pause dubbing, press PAUSE (6).

4 To end Audio Dubbing, press PAUSE (6), then STOP (5).

Stereo microphone

AUDIO

MONITOR T W

DISPLAY

A.DUB

PLAY	PAUSE
RM-V711U	STOP
(provided)

NOTES:

●When editing onto a tape that was recorded at 32 kHz, the old and new soundtracks are recorded separately.

●To select the desired sound for playback, press AUDIO MONITOR on the remote control.

●If you dub onto a blank space on the tape, the sound may be disrupted. Make sure you only edit recorded areas.

●If feedback or howling occurs during TV Playback, move the camcorder’s microphone away from the TV, or turn down the TV’s volume.

●Sound is not heard from the speaker during Audio Dubbing.

●If you change from 32 kHz to 48 kHz in mid-recording and then use the tape for Audio Dubbing, it is not effective from the point where 48 kHz recording began.

●During Audio Dubbing, when the tape moves to scenes recorded in the LP mode, scenes recorded at 48 kHz or a blank portion, Audio Dubbing stops and “ERROR! REFER MANUAL” appears.

Recording sound	Display	Output sound
	FULL SOUND	Original and new tracks are combined and output in stereo.
32 kHz	SOUND 2	New track is output on both “L” and “R” channels in stereo.
	SOUND 1	Original track is output on both “L” and “R” channels in stereo.