EN57
SYMPTOM
39.An error indication (E01 — E06) appears.
40.The charger indicator on the AC Power Adapter/ Charger does not light.
41.Picture does not appear on the LCD monitor.
42.When the image is printed from the printer, a black bar appears at the bottom of the screen.
43.When the camcorder is connected via the DV connector, the camcorder does not operate.
POSSIBLE CAUSES |
| CORRECTIVE ACTION |
39. •A malfunction of some kind |
| 39. • Remove the power supply |
has occurred. In this case |
| (battery pack, etc.) and wait a |
the camcorder’s functions |
| few minutes for the indication |
become unusable. |
| to clear. When it does, you |
|
| can resume using the |
|
| camcorder. |
|
| If the indication remains even |
|
| though you repeat the above |
|
| two or three times, please |
|
| consult your nearest JVC |
|
| dealer. |
|
|
|
40. •The temperature of the |
| 40. • To protect the battery, it is |
battery is extremely high/low. |
| recommended to charge it |
•Charging is difficult in |
| in places with a temperature |
places subject to extremely |
| of 10°C to 35°C (50°F to |
high/low temperatures. |
| 95°F) ( pg. 64). |
|
|
|
41. •The lens cap is attached. |
| 41. •Remove the lens cap |
•The LCD monitor's |
| ( pg. 14). |
brightness setting is too |
| • Adjust the brightness of the |
dark. |
| LCD monitor ( pg. 14). |
|
| • If the monitor is tilted |
|
| upward 180 degrees, open |
|
| the monitor fully ( pg. 15). |
|
|
|
42. •This is not a malfunction. |
| 42. • By recording with “DIS” |
|
| activated ( pg. 24) this |
|
| can be avoided. |
|
|
|
43. •The DV cable was plugged/ |
| 43. • Turn the camcorder’s power |
unplugged with power |
| off and on again, then |
turned on. |
| operate it. |
|
|
|
