JVC GR-DVX818 PRO Insert Editing, Find Edit OUT Point, Find Edit in Point, Pause During Editing

66EN EDITING (Cont.)

Insert Editing

You can record a new scene into a previously recorded tape, replacing a section of the original recording with minimal picture distortion at the in- and out-points. The original audio remains unchanged.

NOTE:

Insert Editing is not possible on a tape recorded in the LP mode or on a blank portion of a tape.

6w

TC 12 : 34

Remote sensor

START/STOP

	T W
	DISPLAY
Power Dial	INSERT

	PLAY
RM-V711U	PAUSE
(provided)	REW(IND)

1 FIND EDIT OUT POINT

Playback the tape to locate the point where you want to stop editing. Confirm the time code at this point (☞ pg. 53).

2 FIND EDIT IN POINT

Press REW until the point is located, then press

PAUSE.

3 PREPARE FOR INSERT EDITING Press and hold INSERT on the remote control, then press PAUSE. “6w” and the Time Code (min.:sec.) appear and the camcorder enters Insert-Pause mode.

4 START RECORDING

Press START/STOP to begin editing.

•Confirm the insert at the time code you checked in step 1.

5 PAUSE DURING EDITING

Press START/STOP. The camcorder re-enters Insert Pause mode. Press again to resume editing.

6 STOP EDITING

Press STOP while the camcorder is in the Insert-Pause mode.

NOTES:

●P.AE/Effects (☞ pg. 42) can be used to spice up the scenes being edited during Insert Editing.

●To display the Time Code during Insert Editing, ☞ pg. 52.

●When performing Insert Editing, the tape’s Video Area and Sub-Code Area (☞ pg. 6) are rewritten, so the date and time information changes.

●If you perform Insert Editing onto a blank space on the tape, the audio and video may be disrupted. Make sure you only edit recorded areas.

●During Insert Editing, when the tape moves to scenes recorded in the LP mode or a blank portion, Insert Edting stops and “ERROR! REFER MANUAL” appears.