60 EN
M 0 : 12 : 34
USING THE REMOTE CONTROL UNIT
(cont.)Insert Editing (VIDEO)
You can record a new scene onto a previously recorded
tape, replacing a section of the original recording with
minimal picture distortion at the in- and out-points. The
original audio remains unchanged.
NOTE:

Use the RM-V709U remote control unit to perform this

procedure.

1
SELECT OPERATION SYSTEM AND
MODE
Set the System Select Switch to “VIDEO”, and set the
Power Switch to “PLAY”.
2

FIND EDIT-OUT POINT

Play back the tape, locate the point and press PAUSE
on the camcorder or the remote control.
3

RESET COUNTER

Press and hold COUNTER R/M for more than
1 second to reset the tape counter, then press again
for less than 1 second so that “M” appears.
4
FIND EDIT-IN POINT
Press REW to go a little beyond the beginning of the
scene you want to replace, press PLAY to view the
recorded tape, and press PAUSE exactly at the
point where the new scene should start.
5

ENGAGE INSERT EDITING MODE

Press and hold INSERT, and without releasing
INSERT, press and release PAUSE. The Insert Editing
mode is engaged. When the scene the camcorder is
aimed at appears on the screen, go to the next step.
6

BEGIN INSERT EDITING

Press START/STOP. When the counter reaches
“0:00:00”, editing stops automatically and the
camcorder enters the Insert-Pause mode.
7

END INSERT EDITING

Press STOP.
NOTES:
●

During Insert Editing, the original audio will be heard

from the speaker.

●

After step 5, Retake (

Z

pg. 23) can be performed.

●

The tape may stop slightly before or after the designated

end point, and noise bars may appear. Neither indicates

a defect in the unit.

●

Only the video signal is recorded in the Insert Editing

mode.

REW
Insert editing
indicator
Display
COUNTER R/M Button
Tape counter
REW (
2
) Button
FF (
3
) Button
PLAY/PAUSE (
4
/6) Button
STOP (5) Button
START/STOP
PLAY
Remote sensor
Power Switch
System Select Switch
STOP
INSERT
RM-V709U
(provided)
PAUSE