EJECT Switch

Cassette holder

Close Button

EJECT Switch

Cassette holder

Close Button

Turn to take up slack.

Erase Protection tab

Gear

EN13

Loading/Unloading A Cassette

1 Open the LCD monitor fully (models equipped with LCD monitor only).

2 Slide EJECT until the cassette holder opens. Do not use force to open.

3 Insert or remove a cassette. When inserting, make sure the label is facing outward.

4 Press the Close button to close the cassette holder until it locks into place.

5 Close the LCD monitor (models equipped with LCD monitor only).

NOTES:

●Closing the LCD monitor while the cassette holder is still open may cause damage to the LCD monitor

(models equipped with LCD monitor only).

●The cassette holder can’t be opened unless a power supply is attached.

●Make sure that the tape is not slack when loading the cassette. If there is any slack, turn the gear on the cassette in the direction of the arrow to take up the slack.

●Make sure the Erase Protection tab is in the position that allows recording. If not, slide the tab. Some cassettes have removable tabs. If the tab has been removed, cover the hole with adhesive tape.

●The cassette holder cannot be opened while the camcorder is in the record mode.