GETTING STARTED
GETTING STARTED
Hook on
Push in
Power Switch
BATTERY RELEASE
Switch
Battery pack
Using the Battery Pack
Perform step 1) of “Charging the Battery Pack”.
Approximate recording time (unit: min.)
Battery Pack | Viewfinder on | LCD monitor on |
|
|
|
95 | 80 | |
|
|
|
100 | 85 | |
(optional) |
|
|
|
|
|
160 | 140 | |
(optional) |
|
|
|
|
|
380 | 330 | |
(optional) |
|
|
|
|
|
Using AC Power
To AC outlet
To DC IN connector
Connect the AC Adapter to the camcorder ( step 2) and 3) of “Charging the Battery Pack”).
AC Adapter |
Charging the Battery Pack
1)Hook the end of the battery pack to the camcorder and push the battery in until it locks
in place.
•If the battery pack is attached wrongly, a malfunction may occur.
2)Set the Power Switch # to “OFF” while pressing down the Lock Button ". Connect the AC Adapter to the DC IN connector 9, then connect the Power Cord to the AC Adapter.
3)Plug the Power Cord into an AC outlet. The CHARGE lamp $ blinks to indicate charging.
4)When the CHARGE lamp $ stops blinking but stays lit, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.
To Detach The Battery Pack…
…slide BATTERY RELEASE 8 and pull out the battery pack.
Battery Pack | Charging time |
| approx. 1 hr. 30 min. |
|
|
approx. 1 hr. 40 min. | |
|
|
approx. 2 hrs. 40 min. | |
|
|
approx. 5 hrs. 10 min. | |
|
|
Charging time is for a fully discharged battery pack.
•The provided AC Adapter features automatic voltage selection in the AC range from 110V to 240V.
ATTENTION:
Before detaching the power source, make sure that the camcorder’s power is turned off. Failure to do so can cause the camcorder to malfunction.
REFRESH:
Be sure to fully discharge a battery pack before recharging or storing it for a long period of time, otherwise the battery performance will be reduced.
1)Perform steps 1) through 3) of “Charging the Battery Pack”.
2)Press REFRESH ! for over 4 seconds. The CHARGE lamp $ blinks faster to indicate discharging.
3)When discharging is finished, charging automatically starts and the CHARGE lamp $ blinks normally.
8
