TROUBLESHOOTING
Before consulting your JVC dealer, please check the following to see if you can correct the problem yourself.
TROUBLESHOOTING
Vertical white lines appear when shooting a very bright object.
•This sometimes occurs when the contrast between the background and the object is great. It is not a defect of the camcorder.
Bright,
•Sunlight is directly entering the lens. This is not a defect of the camcorder.
Coloured bright spots appear all over the LCD monitor or the viewfinder.
•The LCD monitor and the viewfinder are made with
Animation or Time-Lapse is not available.
•Before recording in the Animation mode at the very beginning of a tape, set the camcorder to the Recording mode for about 5 seconds, so that the tape runs smoothly. Using the
The tape is running, but there is no play- back picture.
•The TV has not been set to its VIDEO mode or channel.
•If A/V connection is used, the TV’s VIDEO/TV Switch has not been set to VIDEO.
Playback picture is blurred or interrupted.
•The video heads are dirty or worn out. Consult your nearest JVC dealer for head cleaning or replacement.
The tape stops during
•The Counter Memory Function has been activated ( pg. 17, “COUNTER MEMORY”).
The date and time displays disappear.
•If you remove the power source from the camcorder while the power is on, all settings and selections are erased. Make sure to turn the camcorder’s power off before disconnecting the power source.
The tape will not eject.
•The battery pack is running low.
•If the LCD monitor is not open over 60 degrees, the EJECT button ( does not function.
The camcorder is a
External noise and interference (from a TV, a radio, etc.) might prevent it from functioning properly. In such cases, first disconnect its power supply unit (battery pack, AC Adapter, etc.); and then re- connect it and proceed as usual from the beginning.
WARNING INDICATIONS:
(high) 
(exhausted) : Displays the battery remaining power level. As the battery
power comes close to nil, the battery indicator 
blinks (battery power warning). When the battery power is exhausted, power turns off automatically.
: Blinks when no cassette is loaded, or when the erase protection tab is not in the position that allows recording.
TAPE END: Appears when the tape ends during recording, playback or
LENS CAP: Appears for 5 seconds after power is turned on if the lens cap is attached.
CONDENSATION OPERATION PAUSED PLEASE WAIT: These 2 warnings appear alternately every 3 seconds if condensation occurs. In this case, all functions except tape eject and power on/off are disabled. Remove the tape, turn the unit off (without removing the power supply), wait a few minutes for the warnings to clear, and turn it on again.
HEAD CLEANING REQUIRED USE CLEANING CASSETTE: These 2 warnings appear alternately every 3 seconds if dirt is detected on the heads during recording. In this case, use an optional cleaning cassette. If the warning remains after cleaning, consult your nearest JVC dealer.
—E06) show what type of malfunction has occured. If an error indication and warning appear, turn the unit off, remove the power supply (battery, etc.) and wait a few minutes for them to clear. When it does, you can resume using the camcorder. If the indication remains, consult your nearest JVC dealer.
18
