Sharp AR-287 manual Power on and OFF, Auto power shut-off mode, Preheat mode

POWER ON AND OFF

CHAPTER1 GETTING STARTED Power on and off

As an ENERGY STAR® Partner, SHARP has determined that this product meets the ENERGY STAR® guidelines for energy efficiency.

Auto power shut-off mode

If the auto power shut-off mode is enabled, the copier will automatically turn off the power once a programmed length of time has elapsed without any copier operation after the last copy of a run is made or the power is first turned on. The power switch will automatically be turned to the “OFF” position.

To turn the power back on, simply turn the power switch to the “ON” position.

★ KEY OPERATOR See page 21 of the KEY OPERATOR’S GUIDE for setting the auto power shut-off timer. See page 27 of the KEY OPERATOR’S GUIDE for enabling or disabling the auto power shut-off mode.

Preheat mode

The copier will enter the mode once the set time has elapsed without any copier operation after the last copy of a run is made or power is turned on.

When the copier enters the preheat mode, the message “PREHEAT MODE. PLACE ORIGINALS.” will appear.

In this condition, the fuser in the copier is maintained at a lower heat level thereby saving power. The preheat level is, however, high enough to allow the copier to come to a ready condition or begin copying approximately 30 seconds after any key input is made.

To copy from the preheat mode, make desired copier selections and press the START key using the normal copying procedure.

★KEY OPERATOR See page 22 of the KEY OPERATOR’S GUIDE for information on setting the preheat mode.

1-6