Sharp AR-287 manual Image Editing Functions, 3-20, Auto, Job Build

IMAGE EDITING FUNCTIONS

The image editing functions include the following functions.

●Job build: Makes copies from a large volume of originals (up to 120 pages) using the document feeder.

●Centering: Shifts the image to the center of copy paper when the original and the copy paper are of different sizes.

●Repeat copy: Produces repeated copies on a single sheet of copy paper.

●B/W reverse: Reverses the black and white areas.

●Binding change: Rotates the image of originals for the second side in the 1-sided to 2-sided copy mode.

These functions are selected by pressing the “IMAGE EDIT” key on the SPECIAL MODES screen and pressing the key of each function.

CHAPTER3		JOB BUILD
SPECIAL					Original
			a			b			c
FUNCTIONS
		1 page			21 page			71 page
Image	20 sheets			50 sheets			50 sheets
	Divide the original containing more than
	50 pages into some sections as shown
editing	above and feed them in the order of c
	b a. The original should be less than
functions	120 pages in total. If the total page
	exceeds 120 (if the above section “a”

exceeds 20 pages), the pages in excess of the limit will be output to the exit area without being copied.

The JOB BUILD function allows copying of multipage documents containing up to 120 pages (the limit, however, might be up to 60 pages of 8-1/2" x 14" or 11" x 17" paper size when the copier is equipped with some option) using the RADF. The original must be divided into sections of up to 50 pages per section. Each section can be fed separately through the RADF for eventual copying into a complete set(s).

●Once a copy job is set in this mode, the copy mode can not be changed between the simplex and duplex modes except for INTERRUPT copying.

●When the JOB BUILD function is selected, the below mentioned functions can not be selected simultaneously. GROUP MODE/TRANSPARENCY INSERTS/DUAL PAGE COPY/REPEAT COPY.

●The JOB BUILD mode has priority over the stream feeding mode. Stream feeding will not operate while the JOB BUILD mode is selected.

The illustration shows an example when copying 120 pages of original.

Divide the multipage document (maximum 120 pages)

1 into sections of 50 pages or less and place the section containing the first page of the document into the document feeder tray.

If a duplex copy mode is required, it must be selected at

2 this time by pressing the 2-SIDED COPY key.

AUTO

3-20