Sharp AR-287 manual Cartridge, Check that the first staple of the cartridge is at the tip

FINISHER (AR-FN2)

Staple jam removal

The message “CHECK STAPLER POSITION OR STAPLE JAM” will appear either when the staple cartridge is empty or when there is a staple jam. Please proceed as follows. Open the stapler cover and remove the staple cartridge by lifting the green release lever.

●If the cartridge is empty (a few staples might remain in the cartridge), refer to the section entitled “Staple Cartridge Replacement” on page 7-26.

●If there are sufficient staples left in the cartridge, the stapler is jammed. Remove the jammed staples in the manner described below.

STAPLE TEAR line

1 Close and open the stapler cover.

2 Remove all copies from the tray.

Insert a new sheet of paper (8-1/2” x 11” or A4 size) to

3 the tray as shown in the picture to make the stapler work properly.

	Check that the first staple of the cartridge is at the tip of	Finisher(AR-FN2)	OPTIONALEQUIPMENT
4 the cartridge.
	● If the first staple is not at the tip, pull it to the tip. If any staples are
	protruding past the cartridge tip, tear them off at the STAPLE
	TEAR line and align the first staple with the tip.
5	Push the staple cartridge in until it locks in place.	CHAPTER7
6	Close the stapler cover.
	● The stapler will strike three times, whereupon the jammed

staples will have been removed automatically.

●Remove the paper from the tray.

●To check that the stapler works properly, copy an original and staple it.

7-27