Sharp AR-287 manual Custom Settings key, Sided Copy key, Output key, Scan key, Exposure display

PART NAMES AND FUNCTIONS

Touch Panel (Basic screen)

READY TO COPY.

ORIGINAL 8/1211

1	11R
8/2

1.8/1211

2.1117

AUTO

EXPOSURE

AUTO 8/1211

PAPER SELECT

100%

COPY RATIO

CUSTOM SETTINGS key

Press to set key operator programs or adjust the contrast of the touch panel.

2-SIDED COPY key

Press to select the 1-sided to 1-sided, 1-sided to 2-sided, 2-sided to 1-sided or 2-sided to 2-sided copy mode.

OUTPUT key

Press to select the finisher mode: SORT or

GROUP.

SCAN key

Press to select the network scanner function. (Optional Printer Expansion Kit and Network Scanner Expansion Kit must be installed.)

EXPOSURE display

Indicates the selected exposure mode.

EXPOSURE key (p. 2-16)

Press to select the exposure mode: AUTO, TEXT, TEXT/PHOTO, or PHOTO.

PAPER SELECT display

Displays the selected paper size. When “AUTO” is displayed, paper size matching the original and copy ratio will be automatically selected.

PAPER SELECT key

Press to select the desired paper tray.

COPY RATIO display

Displays the copy ratios for reductions or enlargements.

COPY RATIO key

Press to select a reduction or enlargement copy ratio or select the automatic copy ratio selection mode.

REVIEW key

Press to check the settings of selected functions.

	6CHAPTER
Initial settings
The copier assumes the initial settings when the
CLEAR ALL ( CA ) key is pressed and approximately 1
minute after the last copy is made in any mode.
Except for the paper tray selection, the copier also

● Copy quantity: 0			Partnames	GENERAL
assumes the initial setting when it is turned on.
● Copy ratio: 100%
● Automatic exposure			andfunctions	INFORMATION
● All special copier modes are set to off.
● Tray select: Paper tray 1 (At power on, the
previously selected tray will again be selected.)
Optional large capacity tray will be selected when
installed.
★ KEY OPERATOR	Initial settings can	be

programmed as desired. The auto clear time can also be changed. See pages 17 and 21 of the KEY OPERATOR’S GUIDE.

6-5