Sharp AR-287 Close the stapler cover, Push the new staple cartridge in until it clicks in place

FINISHER (AR-FN2)

Staple cartridge replacement

The message “ADD STAPLES.” will appear when the staple cartridge is empty. Replace the staple cartridge as follows:

OPTIONAL EQUIPMENT7

Finisher (AR-FN2) CHAPTER

STAPLE TEAR line

1 Open the stapler cover.

Lift the green release lever and remove the staple

2 cartridge from the stapler.

●A few staples will be left in the cartridge. Remove and discard them.

Insert a new sheet of paper (8-1/2” x 11” or A4 size) to

3 the tray as shown in the picture to make the stapler work properly.

Check that the first staple in the new cartridge is at the

4 tip of the cartridge.

●If the first staple is not at the tip, pull it to the tip. If any staples are protruding past the cartridge tip, tear them off at the STAPLE TEAR line and align the first staple with the tip.

●A cartridge holds 5,000 staples.

5	Push the new staple cartridge in until it clicks in place.
6	Close the stapler cover.
	● The stapler will strike three times without stapling and feed

staples automatically.

● Remove the paper from the tray.

● To check that the stapler works properly, copy an original and staple it.

7-26