Sharp AR-287 SPECIAL PAPERS manual feed, 2-14, document glass 2 Open the bypass tray

SPECIAL PAPERS (manual feed)

CHAPTER2

The bypass tray is used to copy onto transparency film, labels, tracing paper, and other special purpose papers. Up to 50 sheets of standard copy paper can be set in the bypass tray.

●Automatic duplex copying will not work when a non-standard sized paper is used. If a duplex copying mode is selected and a non- standard sized paper is used from the bypass tray, the corresponding one-sided mode will be selected automatically when the START key is pressed.

MAKING COPIES Special papers (manual feed)

1	11		1
/2			8/2 11R
1	17
	1	11	100%
O 8/2
R SELECT			COPY RATIO

CLEAR ALL

CA

START

Place the original in the document feeder tray or on the

1 document glass.

2 Open the bypass tray.

Set the bypass tray guides to the width of the copy

3 paper.

●Be sure to extend the tray when feeding 8-1/2" x 11"R, 8-1/2" x 14" or 11" x 17" sized paper.

When feeding 11" x 17" sized paper, pull out the metallic support.

4	Insert the copy paper all the way into the bypass tray.
	● Labels, tracing paper, and other special purpose papers other
	than SHARP recommended transparency film must be fed
	individually. Multiple sheets of SHARP recommended
	transparency film can be loaded in the bypass tray.
	● Up to 50 sheets of standard copy paper measuring from
	5-1/2" x 8-1/2" to 11" x 17" can be loaded into the bypass tray.
	● When adding paper, first remove remaining paper, combine it
	with the paper to be added and then reload as a single stack.
	Press the “PAPER SELECT” key on the touch panel and
5 then select the bypass tray.
6	Set the number of copies.
7	Press the START key.

2-14