Sharp AR-287 manual Cautions

CAUTIONS

1.Do not touch the photoconductive drum. Scratches or smudges on the drum will cause dirty copies.

2. The fusing unit is extremely hot. Exercise care in this area.

3. Since a hard disk drive is built into the copier, be sure to turn the	Fusing unit
	Photoconductive
power switch to the “OFF” position when moving the copier. Take
	drum
care not to subject the copier to any vibration or shock.

4.Do not look directly at the light source. Doing so may

damage your eyes.

CHAPTER1 GETTING STARTED Cautions

5.Four installation adjusters are provided on the optional stand/500-sheet paper drawer.

When moving the machine with the optional stand/500- sheet paper drawer, be sure to raise the installation adjusters. After moving the machine, lower the four installation adjusters until they reach the floor and lock the two casters at the front of the copier.

6.When copying is interrupted (for example, because the INTERRUPT function has been used, paper or toner has run out, a misfeed has occurred, etc.), this copier will store the image data of the originals read prior to the interruption. If copying of secret documents is interrupted due to the above reasons, be sure to either resume the interrupted copying by pressing the START key, or clear the image data by pressing the CLEAR ALL key after the interrupt copying is completed or the trouble is cleared, because the stored data may be printed by other operators.

“BATTERY DISPOSAL”

CONTAINS MANGANESE DIOXIDE LITHIUM BATTERY. MUST BE DISPOSED OF PROPERLY. CONTACT YOUR SHARP DEALER OR SERVICER FOR INSTRUCTIONS.

Caster

Release

Lock Release

Lock

Adjuster

1-3