Grip Adjustment, Viewfinder Adjustment, 180

Grip Adjustment

1)Separate the Velcro strip.

2)Pass your right hand through the loop and grasp the grip.

3)Adjust so that your thumb and fingers can easily operate the Recording Start/Stop Button ! and Power Zoom Lever 3. Refasten the Velcro strip.

Viewfinder Adjustment

1) Set the Power Switch @ to “ ” or “ ”.

2)Turn the Dioptre Adjustment Control o until the indications in the viewfinder are clearly focused.

180°

PAUSE

Tripod Mounting

Align the screw and camera direction stud on the tripod with the tripod mounting socket W. Then tighten the screw.

CAUTION

When using a tripod, be sure to open and extend its legs fully to stabilise the camcorder. To prevent damage to the unit caused by falling over, do not use a small-sized tripod.

Loading/Unloading A Cassette

1)Open the LCD monitor fully*. Slide EJECT t until the cassette holder opens. Do not use force to open.

2)Insert or remove a cassette. When inserting, make sure the label is facing outward. D appears when a cassette is loaded.

3)Press the Close button i to close the cassette holder until it locks into place. Close the LCD

monitor*.

•Closing the LCD monitor while the cassette holder is still open may cause damage to the LCD monitor*.

•Make sure the erase protection tab is in the position that allows recording. If not, slide the tab. Some cassettes have removable tabs. If the tab has been removed, cover the hole with adhesive tape.

•The cassette holder cannot be opened while the camcorder is in the record mode or detached from the power source.

* Applicable models only.

Shoulder Strap Attachment

Thread the strap through the eyelet y, then fold it back and thread it through the buckle. Repeat the procedure to attach the other end of the strap to the other eyelet y, making sure the strap is not twisted. Adjust the length.

Cassette holder

t Gear

Turn to take up slack.

i	Erase Protection tab