26
Playback Zoom
To magnify the recorded image up to 10X at any
time during playback. Make sure that the TBC
mode is activated.
1)Press PLAY R to find the scene of interest.
2)Press ZOOM (T/W) E. Pressing T zooms in. To
end zoom press and hold W until magnification
returns to normal. Or, press STOP Y and then
press PLAY R.
•Due to digital image processing, the quality of the
image may suffer.
Animation And Time-Lapse
The remote control lets you set/release interval
time and recording time without setting REC TIME/
INT. TIME ( pg. 21) in SYSTEM MENU.
Animation
Each time ANIM. I is pressed, the recording time
changes in the following order: 1/4S, 1/2S, 1S, 5S
and no indication (off).
Time-Lapse
Each time REC TIME I is pressed, the recording
time changes in the following order: 1/4S, 1/2S,
1S, 5S and no indication (off). Each time INT. TIME
d is pressed, the interval time changes in the
following order: 15S, 30S, 1MIN, 5MIN and no
indication (off).
Insert Editing
You can record a new scene onto a previously
recorded tape. Only the video signal is recorded in
this mode.
1)Set the Power Switch @ to “ ” while pressing
down the Lock Button ! located on the switch.
2)Play back the tape, locate the edit-out point and
press PAUSE a. Press and hold COUNTER R/M
w for more than 1 second to reset the tape
counter, then press it again for less than
1 second so that “M” appears.
3)Press REW T to go a little beyond the beginning
of the scene you want to replace, press PLAY R
to view the recorded tape, and press PAUSE a
exactly at the edit-in point where the new scene
should start.
4)While holding down INSERT U, press and
release PAUSE a. w appears.
5)To begin Insert Editing, press START/STOP O.
When the counter reaches “0:00:00”, editing
stops automatically and the camcorder enters
the Insert-Pause mode. To end Insert Editing,
press STOP Y.
•During Insert Editing, the original audio will be
heard from the speaker.
•After step 4), “Retake” ( pg. 13) can be
performed.
•The tape may stop slightly before or after the
designated end point, and noise bars may appear.
Neither indicates a defect in the unit.
GR-SXM967-EN 3/11/03, 10:33 AM26