JVC GR-SXM37 manual Getting Started, Refresh

GETTING STARTED

Hook on

Push in

Power Switch

BATTERY RELEASE

Switch

Battery pack

To AC outlet To DC IN

connector

AC Adapter

Charging the Battery Pack

1)Hook the end of the battery pack to the

camcorder and push the battery in until it locks in place.

•If the battery pack is attached wrongly, a malfunction may occur.

2)Set the Power Switch $ to “OFF” while pressing down the Lock Button #. Connect the AC Adapter to the DC IN connector !, then plug the AC Adapter to the AC Outlet.

3)The CHARGE lamp % blinks to indicate charging.

4)When the CHARGE lamp % stops blinking and turns off, charging is finished. Unplug the AC Adapter from the AC outlet. Disconnect the AC Adapter from the camcorder.

To Detach The Battery Pack…

…slide BATTERY RELEASE 9 and pull out the battery pack.

Battery Pack	Charging time
BN-V10U	approx. 1 hr. 30 min.
BN-V12U (optional)	approx. 1 hr. 40 min.
BN-V20U (optional)	approx. 2 hrs. 40 min.
BN-V400U (optional)	approx. 5 hrs. 10 min.

Charging time is for a fully discharged battery pack.

Using the Battery Pack

Perform step 1) of “Charging the Battery Pack”.

Approximate recording time (unit: min.)

Battery Pack	Viewfinder on	LCD monitor on
BN-V10U	95	80
	(50)	(45)
BN-V12U	100	85
(optional)	(55)	(50)
BN-V20U	160	140
(optional)	(85)	(80)
BN-V400U	380	330
(optional)	(210)	(195)

Using AC Power

Connect the AC Adapter to the camcorder (
step 2) of “Charging the Battery Pack”).

•The provided AC Adapter features automatic voltage selection in the AC range from 110V to 240V.

ATTENTION:

Before detaching the power source, make sure that the camcorder’s power is turned off. Failure to do so can cause the camcorder to malfunction.

REFRESH:

Be sure to fully discharge a battery pack before recharging or storing it for a long period of time, otherwise the battery performance will be reduced.

1)Perform steps 1) through 3) of “Charging the Battery Pack”.

2)Press REFRESH " for over 4 seconds. The CHARGE lamp % blinks faster to indicate discharging.

3)When discharging is finished, charging automatically starts and the CHARGE lamp % blinks normally.

GETTING STARTED

7