Speaker
Load a cassette. ( pg. 16)

20 EN

NOTES:

● The time code cannot be reset.

VIDEO PLAYBACK

Normal Playback

● During fast-forwarding and rewinding, the time

code indication does not move smoothly.

● The time code is displayed only when “TIME

4/9

VIDEO/MEMORY Power Switch

CODE” is set to “ON”. ( pg. 36)

Quick Review

Enables to check the end of the last recording.

1)Press QUICK REVIEW (3) during the record-standby mode.

2)Tape is rewound for about several seconds and played back automatically, then pauses in the record-standby mode for the next shot.

● Distortion may occur at start of playback. This is not a malfunction.

Recording from the Middle of a Tape

1)Play back a tape or use blank search

( pg. 21) to find the spot at which you want to start recording, then engage the still playback (pause) mode. (See the right column.)

2)Set the power switch to “A” or “M” while pressing down the lock button located on the switch, then start recording.

3 5

A

Lock Button

MENU 8

VOL. +, –

1

2 Set the VIDEO/MEMORY switch to “VIDEO”.

3 Set the power switch to “PLAY” while pressing down the lock button located on the switch.

4 To start playback, press 4/9.

5 To stop playback, press 8.

●During stop mode, press 3to rewind, or 5to fast-forward the tape.

To control the speaker volume

Slide the power zoom lever (VOL. +, –) towards “+” to turn up the volume, or towards “–”to turn down the volume.

NOTES:

●The playback picture can be viewed in the LCD monitor or on a connected TV. ( pg. 22)

●If Stop mode continues for 5 minutes when power is supplied from a battery, the camcorder shuts off automatically. To turn on again, set the power switch to “OFF”, then to “PLAY”.

●When a cable is connected to the S/AV connector, the sound is not heard from the speaker.

Still Playback (Pause)

Pauses during video playback.

1)Press 4/9 during playback.

2)To resume normal playback, press 4/9 again.

●If still playback continues for more than about 3 minutes, the camcorder’s Stop mode is automatically engaged.