VIDEO RECORDING & PLAYBACK | MasterPage: Video_Heading0_Right |
|
| VIDEO RECORDING EN 17 | |
Basic Recording | Tape Remaining Time | |
Approximate tape remaining | ||
NOTE: | ||
time appears on the display. | ||
Before continuing, perform the procedures listed | “– h – – m” means the | |
below: | camcorder is calculating the | |
● Power ( pg. 11) | remaining time. When the | |
● Loading A Cassette ( pg. 16) | remaining time reaches 2 minutes, the indication | |
Power Zoom Lever | starts blinking. | |
● The time required to calculate and display the | ||
| ||
Power Switch | remaining tape length, and the accuracy of the | |
calculation, may vary according to the type of tape | ||
| ||
Lock Button | used. | |
| ||
POWER/CHARGE Lamp |
| |
Recording Start/Stop Button |
|
1 Remove the lens cap. ( pg. 10)
2 Open the LCD monitor fully.
3 Set the Power Switch to “A” or “M” while pressing down the Lock Button located on the switch.
●The POWER/CHARGE lamp lights and the camcorder enters the
●To record in LP (Long Play) mode, pg. 23.
4 To start recording, press the Recording Start/ Stop Button. “T REC” appears on the display while recording is in progress.
5 To stop recording, press the Recording Start/ Stop Button again. The camcorder
Approximate recording time
Tape | Recording mode | |
|
| |
| SP | LP |
|
|
|
30 min. | 30 min. | 45 min. |
|
|
|
60 min. | 60 min. | 90 min. |
|
|
|
80 min. | 80 min. | 120 min. |
|
|
|
NOTES:
●If the
5 minutes, the camcorder’s power shuts off automatically. To turn the camcorder on again, push back and pull out the viewfinder again or close and
●When a blank portion is left between recorded scenes on the tape, the time code is interrupted and errors may occur when editing the tape. To avoid this, refer to “Recording From The Middle Of A Tape” ( pg. 19).
●To turn the beep sounds off, pg. 22, 25.
VIDEO RECORDING & PLAYBACK
