![](/images/backgrounds/210670/bg28.png)
TROUBLESHOOTING
40 EN
MasterPage: Left
●The viewfinder is pulled out and “PRIORITY” is
set to “FINDER”.
HPush the viewfinder back in or set “PRIORITY” to
“LCD”. (墌pg. 18,22, 25)
●The LCD monitor’s brightness setting is too dark.
HAdjust the brightness of the LCD monitor.
(墌pg. 15)
HIf the monitor is tilted upward 180 degrees, open
the monitor fully. (墌pg.18)
●A malfunction of some kind has occurred. In this
case the camcorder’s functions become
unusable.
H墌pg. 41.
Warning I ndicatio nsDisplays the battery remaining power.
Remaining power level
As the battery power comes close to nil, the
battery remaining power indicator blinks.
When the battery power is exhausted, power
turns off automatically.
Appears when no tape is loaded. (墌pg. 16)
Appears when the erase protection tab is set to
“SAVE” while the Power Switch is set to “A” or
“M”. (墌pg. 13)
Appears if dirt is detected on the heads during
recording. Use an optional cleaning cassette.
(墌pg. 44)
Appears if condensation occurs. When this
indication is displayed, wait more than 1 hour
until condensation disappears.
Appears if a tape is not loaded when the
Recording Start/Stop Button or SNAPSHOT
Button is pressed while the Power Switch is set
to “A” or “M”.
Appears when the tape ends during recording or
playback.
●Appears when the date/time is not set.
(墌pg. 14)
●The built-in clock battery has run out and the
previously set date/time has been erased.
Consult your nearest JVC dealer for
replacement.
Picture does not appear on the LCD
monitor.
An error indication (01 – 04 or 06) appears.
CHECK TAPE’S ERASE PROTECTION TAB
USE CLEANING CASSETTE
CONDENSATION, OPERATION
PAUSED PLEASE WAIT
TAPE !
TAPE END
SET DATE/TIME!
ExhaustedHigh
GR-D240PAL.book Page 40 Wednesday, November 17, 2004 7:32 PM