Connections
Speaker layout
| Center speaker | ||
Front left |
|
| Front right |
speaker |
|
| speaker |
Subwoofer
Surround left | Surround right |
speaker | speaker |
• Place the satellite speakers on a flat and level surface.
•The front and center speakers are magnetically shielded to avoid color distortions on TVs. However, if not installed properly, they may cause color distortions. So, pay attention to the following when installing the speakers.
–When placing the speakers near a TV set, turn off the TV’s main power switch or unplug it before installing the speakers. Then wait
at least 30 minutes before turning on the TV’s main power switch again.
Some TVs may still be affected even though you have followed the above. If this happens, move the speakers away from the TV.
•The surround speakers and the subwoofer are not magnetically shielded.
If it is located nearby the TV or monitor, it will probably cause color distortion on the screen. To avoid this, do not place the speaker nearby the TV or monitor.
•Be sure to place the subwoofer to the TV’s right. If you place the subwoofer to the TV’s left, keep sufficient distance between them to prevent the TV screen from appearing mottled.
Connecting a TV
•Distortion of picture may occur when connecting the TV via a VCR, or to a TV with a
•You need to set “MONITOR TYPE” in the PICTURE menu correctly according to the aspect ratio of your TV. (See page 32.)
Center unit
TV
To SCART connector
*Some TV’s SCART connectors output audiosignal. In such a case, you can enjoy the TV sound through this system.SCART cable (not supplied)
NOTE
•No sound signal comes out from “AV” (SCART) connector.
•Select the appropriate video signal according to your TV. (See page 15.)
Connecting the power cord
Make sure that all other connections have been completed.
Center unit
Power cord
Plug into AC outlets.
CAUTION
•Disconnect the power cord before cleaning or moving the system.
•Do not pull on the power cord to unplug the cord. When unplugging the cord, always grasp and pull the plug so as not to damage the cord.
NOTE
•Preset settings, such as preset stations and surround mode adjustment, may be erased in a few days in the following cases;
•If you unplug the power cord of the center unit.
•If a power failure occurs.
