JVC HR-A51U Check Contents, Situate VCR, Connect VCR to TV, Connect VCR to Power Source, Use

1

2

3

4

5

CHECK CONTENTS

Make sure the package contains all of the accessories

listed in “SPECIFICATIONS” ( pg. 43).

SITUATE VCR

Place the VCR on a stable, horizontal surface.

CONNECT VCR TO TV

The connection method you use depends on the type of

TV you have.

RF Connection

To Connect To A TV With NO AV Input Terminals . . .

a– Disconnect the TV antenna from the TV.

b– Connect the TV antenna cable to the ANT. IN jack

on the rear of the VCR.

c– Connect the supplied RF cable between the RF

OUT jack on the rear of the VCR and the TV’s

antenna terminal. Set TV on CH3 or CH4

corresponding to the CH3 – CH4 switch setting on

the back of the VCR.

AV Connection

To Connect To A TV With AV Input Terminals . . .

a– Connect the antenna, VCR and TV as shown in

the illustration.

b– Connect an Audio/Video Cable between the AUDIO

OUT and VIDEO OUT jacks on the rear of the VCR

and the AV IN jacks on the TV. Set your TV in video

input mode or A/V input mode. Refer to the TV

Instruction Manual.

CONNECT VCR TO

POWER SOURCE

Connect the power plug to an AC outlet.

The clock and tuner channels will automatically be

set when the antenna is connected and when the AC

is first connected to the VCR ( pg. 8).

(If "Auto" or "CH" is displayed on the front display

panel before the VCR is powered on, the clock and

tuner channels are being set automatically. Wait for

the time to be displayed on the front display panel

before powering on the VCR.)

FINAL PREPARATION FOR

USE

Power on the VCR and select the VCR channel (3 or 4) by setting the switch on the rear of the VCR as shown in the illustration.

You can now perform simple playback ( pg. 16) or simple recording ( pg. 17).

EN7

NOTES:

The VCR channel is the channel on the TV which will display the audio and video signals from the VCR. The VCR's CH3- CH4 switch, on the back of the VCR, sets the VCR channel to CH3 or CH4.

The CH3–CH4 switch is preset to the CH3 position.

Set to CH4 if CH3 is used for broadcasting in your area and set the channel on the TV to correspond to the VCR's CH3– CH4 switch setting.

If RF connection to TV is used, when switching from VCR to TV mode and from TV to VCR it may be necessary to issue a CH UP and then CH DOWN on TV to obtain a good quality picture.

Even if you are using AV cables to connect your VCR to your TV, you must also connect it using the RF cable. This will ensure that you can record one show while watching another ( pg. 26).

For full identification of the VCR's rear panel, refer to the Index (REAR VIEW pg. 41).